Installation & Assembly

6
6
25
27
2
8
29
26
14
16
24
19
B
21
23
24
19
21
23
191715
A
Page 2
Connect stainless steel flex lines (6) from valve outlets to
spout tee (10). Flex lines should be looped as shown
indiagram. FLEX LINES MUST NOT BE KINKED.
Adjust valves and or spout tee to eliminate and kinking in
the flex lines. Install escutcheons onto the valves and hand
tighten. Do not over-tighten. Install handles onto valve
stems
Insert drain plug (21) into drain assembly and insert ball
rod (19) as diagramed. Attach pop-up rod extension (15) to
horizontal ball rod (19) with "V" clip (17). Attach pop-up
rod extension to pop-up rod. To secure drain plug install
the ball rod (19) though the bottom hole (24) as show in
diagram "B". To install the drain plug so that it may be
removed, place the drain plug (24) on top of the ball rod
(19). Adjust the height of the drain plug (21) and pop-up
rod extension so that the basin both seals and drains
adequately. Tighten pop-up rod extension to secure
assembly.
THIS STEP MUST BE COMPLETED TO ADHERE TO
THE LIMITED LIFETIME WARRANTY.
Flush hot and cold supply lines before connecting faucet
to supply lines. Connect the supplies to the bottom of the
lavatory valves using the brass coupling nuts (5) provided
or with a flexible line. Connect your waste P-trap to the
drain tail piece.
Insert drain rim (25) into the basin placing the Teflon
washer (26) under the rim. From below slip on washer (27)
onto the bottom thread of the drain rim and secure to basin
with drain nut and washer (28 and 29).
Step 7 Step 8
Step 9 Step 10