Installation & Assembly

1 1/8"
DIAMETER.
HOLE
f
or HOT &
C
OLD VALVE
MIN. 1 1/2" DIAMETER
SPOUT HOLE
8
7
14
9
1
0
12
11
13
1
4
4
2
3
3
2
3
2
4
Page 1
Should a counter top need to be drilled, please reference
the diagram above.
Install spout tee assembly (9, 10, 11, 12 and 13)
as shown in diagram.
Remove top fastening nut and washer (2 & 3) from the
lavatory valve. (NOTE A: AII lever handle sets are supplied
with one right-hand valve and one left-hand valve. InstaII valve
with the blue dot on the cold side [Round handle sets are
supplied with two hot valves that turn in the same direction]).
Insert valve from below through hole in lavatory or counter-
top.
Insert spout base nipple into center hole in lavatory or
counter top. Install stainless washer (7) and spont (8) on
spout nipple and tighten. Place pop-up knob rod (14) though
spout.
Reattach top fastening nut and washers (2 and 3).
Set valve to proper rough-in height "A", by adjusting bottom-
fastening nut. Secure valve by tightening top fastening nut
*YOU MAY NEED TO CUT THE ALL BROACHED STEM TO
REDUCE THE VISIBILITY BETWEEN HANDLE AND
ESCUTCHEON. Repeat procedure for the second lavatory
valve. Please see page P99030A for the "A" measurement
for your trim.
Step 1 Step 2
Step 3 Step 4
Step 5 Step 6