Installation & Assembly

7
Rough in specifications for wall lavatory tub sets
All Phylrich Doralfe valve installations must follow the measurement for
“A” listed below
Please consult the trim number for correct rough in dimension
PHYLRICH PROD# Rough In
WL101 2 1/4”...............................
WL104 2 3/4”...............................
WL105 2 3/4”...............................
WL123 2 7/8”...............................
WL137 2 3/8”...............................
WL137SF 2 3/8”...............................
WL141 2 3/8”...............................
WL144 2 1/4”...............................
WL158A 2 1/4”...............................
WL158B 2 1/4”...............................
WL158C 2 1/4”...............................
WL158D 2 1/4”...............................
WL170 2 1/2”...............................
WL171 2 1/2”...............................
WL180 2 7/8”...............................
WL181 2 7/8”...............................
WL234 2 1/2”...............................
PHYLRICH PROD# Rough In
WL240 3”...............................
WL241 3”...............................
WL242 3”...............................
WL243 3”...............................
WL244 3”...............................
WL270 2”...............................
WL271 2”...............................
WL272 2”...............................
WL273 2”...............................
WL274 2”...............................
WL338A 2 1/2”...............................
WL338B 2 1/2”...............................
WL338C 2 1/2”...............................
WL338D 2 1/2”...............................
WL338F 2 1/2”...............................
WL361 2 3/8”...............................
DWL100 2 1/4”...............................
PHYLRICH PROD# Rough In
DWL102 2 1/4”...............................
DWL130 2 1/4”...............................
DWL134 2 1/4”...............................
DWL137 2 1/4”...............................
DWL205 2 3/4”...............................
DWL206 2 3/4”...............................
ADJUSTABLE CARTRIDGE KIT 2-197 (1/2” COLD) & 2-198 (1/2” HOT)
Note: If you ordered/ purchased a replacement for the cartridge follow the instructions below.
Nipple Thread All
Stem Extension
Nut
Cartridge
Warning: Before removing any plumbing make
sure that the water line has been shut off
HANDLE ADJUSTMENT
1. Remove any existing cartridge & make sure that
the valve is free from any debris.
2. Install new cartridge.
3. Rotate handle to desired “off” position (3 o’clock
or 9 o’clock) .
4. Remove handle and use a deep socket wrench
(12-14 ft-lb RECOMMENDED) to secure the
adjustment nut DO NOT OVER TIGHTEN
5. If the handle is heavy & starts to droop use a strap
wrench on the threaded nipple as needed
6. Reinstall trim & handle