Installation & Assembly

3
NOTE: COPPER LINES NOT PROVIDED
Once the proper location has been determined secure the valve. Connect the Copper lines
to the hot and cold supplies.
For Female spout : Determine the proper location for the Wall lavatory Valve. (Note: The Wall
tub valve must be a minimum of 2” above the floodplane of the tub.) Install a crossbeam and
connect a 1/2” brass nipple (not provided) to accept the spout. Wall is ready to be closed.
For Male spout : (No need to attach nipple.) Slide spout flange and rubber washer onto spout.
Attach complete spout to the valve. Wall is ready to be closed.
Before installing, know first if you are installing a female spout or a male spout.
8090536R
VALVE
8090536RNL
VALVE
Before starting the installation determine first the rough-in specs to
determine the proper location of the valve.
See page 6 for rough-in specs
Brazed Copper Lines
(not provided)
Brazed Copper Lines
(not provided)
Follow the direction for the continuation of the install guide:
For Wall Lav go to Part 2 ; For Tub Install go to Part 3A ; For Shower install go to part 3B
PART 1 Connection of Copper tubing/lines
PART 2 Wall Lav Installation
Center to
Center 8”
Nipple
NOTE: Check all connections for leaks and flush all lines.
Male spoutFemale spout
Female Spout
Male Spout
Washer
Flange
PROCEED TO PART 4 (Escutcheons & Handles)