INSTALLATION INSTRUCTIONS FOR 8090536R WALL SHOWER/ WALL TUB VALVE 8090536RNL WALL LAVATORY SET VALVE 1
INSTALLATION INSTRUCTIONS FOR 8090536R WALL SHOWER/ WALL TUB VALVE 8090536RNL WALL LAVATORY SET VALVE RECOMMENDED TOOLS & MATERIALS Most of the procedures require the use of common tools & materials, which are available from hardware & plumbing supply stores. It is essential that the tools and materials be on hand before work.
Before starting the installation determine first the rough-in specs to determine the proper location of the valve. See page 6 for rough-in specs PART 1 Connection of Copper tubing/lines Once the proper location has been determined secure the valve. Connect the Copper lines to the hot and cold supplies.
PART 3A Tub Installation Determine the proper location for the Tub spout. (NOTE: the outlet of the spout must be minimum of 2” above the floodplane of the tub). Install a crossbeam and secure a 1/2” brass 90° elbow. Connect elbow to the valve using copper lines. Connect a 1/2” brass nipple to elbow to accept the spout. Wall is ready to be closed.
PART 4 (Escutcheons & Handles) Once the finished wall is in place and the necessary installation finished, attach the escutcheons and handles to the stem assemblies. Escutcheon Handle Proceed to the next step on how to fix trimming issues if applicable. TRIM OUT FINISHED WALL INSTALLED TOO DEEP If the valve is installed too deep behind the wall, extension stems are available.
ROUGH-IN SPECIFICATIONS 4 1/4” MAX. 3 1/2” MIN. A 8” CENTER TO CENTER 2 1/4” MIN. Rough in specifications for wall tub sets All Phylrich valve installations must follow the measurement for “A” listed below Please consult the trim number for correct rough in dimension PHYLRICH PROD# K1101 K1104 K1105 K1123 K1137 K1137SF K1141 K1144 K1158A K1158B K1158C K1158D K1158F K1170 Rough In ............................... 2 1/4” ............................... 2 3/4” ............................... 2 3/4” ......
Rough in specifications for wall lavatory tub sets All Phylrich Doralfe valve installations must follow the measurement for “A” listed below Please consult the trim number for correct rough in dimension PHYLRICH PROD# WL101 WL104 WL105 WL123 WL137 WL137SF WL141 WL144 WL158A WL158B WL158C WL158D WL170 WL171 Rough In ............................... 2 1/4” ............................... 2 3/4” ............................... 2 3/4” ............................... 2 7/8” ...............................
