Daim Ntawv Qhia Tus Neeg Siv

d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis aux
deux conditions suivantes:(1) Cet appareil ne doit pas causer d'interférences(2) Cet appareil doit
accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement
indésirable de l'appareil.
For integration it must be ensured the module is used in the same way as it was used during testing.
3 Limited Module Procedures. KDB 996369 D03, Section 2.4
The module approval is a limited module approval and not for sale. The user manual integration
instructions are internal confidential manufacturing documents.
4 Trace antenna designs. KDB 996369 D03, Section 2.5
The approval is only valid without changing the antenna design.
5 RF exposure considerations. KDB 996369 D03, Section 2.6
The module has very low level of RF energy which is considered compliant without specific absorption
testing or SAR.
6 Antennas. KDB 996369 D03, Section 2.7
The approval is only valid without changing the antenna design.
7 Label and compliance information. KDB 996369 D03, Section 2.8
The device where the component is used must be labeled with “Contains FCC ID: T68-VXP3”, “Contains
IC: 6627A-VXP3”.
This labeling is not required if the FCC and IC number of the module is visible from the outside.
8 Information on test modes and additional testing requirements.
KDB 996369 D03, Section 2.9
N/A
9 Additional testing, Part 15 Subpart B disclaimer. KDB 996369 D03,
Section 2.10
N/A
The firmware of the device cannot be modified or adjusted by the end user.