User Manual

Upon adjustment, press button on transmitter to exit the setting mode.
Ratio Functions
1. To set the Flash Ratio
Press button corresponding to , turn to set the flash ratio from 8:1 to 1:8
in 1/2stop increment.
Upon adjustment, press button to exit the setting mode.
2. Check the Version Info
The Odin II transmitter allows for check the version information at the Ratio
Functions Screen. Press button to display the Ratio Function Screen, and then
press button corresponding to to display the current version information of
the transmitter.
LED Indicator
When left idle, the LED indicators on transmitter and receiver will flash green at
certain frequency. When the camera is in action of focusing, the indicators will light
green; while in action of shooting, the indicators will light red.
Modeling Light Button
Pressing the modeling light button on the transmitter will allow you to adjust the
modeling light brightness (0-9 grades) of Phottix Indra studio light series:
Press button to display the screen for modeling light brightness adjustment; press
the group button to choose the group to set; turn to set the brightness level of
modeling light. Repeat the above operation to set the brightness level of modeling
light for each group.
Press button to exit the setting mode.
Note: The function is not available for hot shoe flashes.
LCD Backlight
The backlight will light up for 8 seconds when pressing any button on the transmitter
and then go off if no buttons are pressed. You can enable or disable the LCD backlight
by setting custom function.