User Manual

9
INSTRUCTION MANUAL
EN
Connecting a ash to the Strato TTL
receiver hot shoe
1. Turn off the flash and the Strato TTL
Receiver.
2. Slide the ash into the receiver’s hot shoe
mount.
3. Lock the flash with the flash’s locking
mechanism.
4. Turn on the flash and the Strato TTL
receiver.
5. Set the ash to TTL mode.
Please Note:
It is not unusual for the flash to discharge
once after turning on the Strato TTL.
Using the Strato TTL to trigger
ashes
1. Half-press the camera shutter button
while the Strato TTL transmitter is connected
to the camera hot shoe and powered on.
When AF-ILL Function is enabled, and it is
dicult for the camera to achieve focus, the
AF assist light of ashes connected to Strato
TTL receivers on the same channel as the
transmitter will illuminate. The Status LEDs on
the transmitter and receiver will turn green.
2. A full-press of the camera shutter button
will fire flashes connected to Strato TTL
receivers on the same channel as the
transmitter. Status LEDs on the Transmitter
and Receiver will turn red.