User guide

INSTRUCTION MANUAL

To Exit Wireless Triggering Mode

1. Press and hold the

button for 2 seconds until “Master” or “Slave” is

highlighted in the upper left corner of the screen;

2. Press the

or buttons to cycle between Master, Slave, OS and

Wireless O modes;

3. Select the Wireless Fn OFF (wireless o) and press the

button to con-

rm.

Using Wireless Triggering

With a ash in Master mode on the camera and remote ashes in Slave mode,

pressing the shutter button will re the Master ash (if set to Master with ash)

and set o any ashes set to Slave mode within the range. The camera and ash

will meter the scene and re ashes in TTL mode to properly expose the scene.

Master Mode: What can be set on the Master ash?

Master Flash Mode: TTL, Manual, Multi, Master without ash, EV adjustments,

Manual (M) mode power level.

Slave Flash Mode: TTL, Manual, Group O, EV adjustments, Manual (M) mode

power level

Channel: Transmission channel

Zoom: Flash Head Zoom on Master ash

Multi Mode Settings: Multi power levels, frequency, ash count

Slave Mode: What can be set on Slave ashes?

Group: A, B or C

Channel: Reception channel

Zoom: Flash Head Zoom on Slave ash

Please note:

If Multi mode is set on the Master ash, all slave ashes will operate in Multi

Mode. Groups can be turned o from the Master. All ashes must use the

same ash power, frequency, ash counts.

The adjustable parameters under wireless ash mode are as follows:

Please note:

1. When in the Wireless Mode interface, press button to enter the setup

screen, then press the

or buttons to cycle between options.

2. Press the

buttons to cycle between parameters;

3. Multi Mode cannot be used with TTL or Manual modes;