User guide

7
The frequency of the eect (in Hz. - number of ashes per second), the total
number of ashes and output levels can be set.
To use:
1. Press the button until Multi is displayed on the ash LCD.
2. Press the
button to adjust Multi settings. Displayed (from left to right
on the LCD) Power, Frequency (HZ) and Flash Count. Power is highlighted and
ashing upon entering the adjustment screen.
3. Press the
and buttons to change between Power, Frequency (HZ)
and Flash count.
4. Press the
and buttons while the setting is highlighted to ad-
just Power, Frequency (HZ) and Flash count to the desired levels.
5. Press the
button to exit the adjustment screen.
Please note:
1. Overheating and damage can result from excessive use of the Multi Strobo-
scopic Mode. Do not use more than 20 times in succession.
En
INSTRUCTION MANUAL
2. When overheated the ash will automatically increase charging time until
the ash temperature has decreased.
Stroboscopic Mode and Shutter Speeds
To determine the proper camera shutter speed to be used with various Strobo-
scopic Mode variables, use the following formula:
Number of ashes / Frequency = Shutter Speed
Example: 5x (number of ashes) / 10 Hz (Frequency) = 0.5 second shutter speed.
This is a rough guideline: You may need to increase or decrease the shutter
speed to get the desired result.
Multi Stroboscopic Mode Output Chart