Installation Instructions

For Customer Service, contact the place of purchase to arrange for replacement parts.

ASSEMBLING THE FIXTURE as Chain hung (Fig.2)

1. Remove the Circular strap from top of Fixture and

replace the long mounting screws with two short screws

to hold the Deco nuts (E) in place on the fixture Top cap

(D).

2. Feed the fixture wires through the Top loop (D2) and

pull the wires until taut. Then screw the Top Loop（D2）

to the coupling on the top of fixture (D) until tight.

3. By measuring determine correct number of links

needed for proper hanging height. Use a pair of pliers to

open one link of the Chain (C2) then remove the excess

Chain (C2) and discard it.

4. Use one chain connector(E2) to attach one end of the

chain to the Top loop (D2) and close the chain connector.

5. Feed the fixture wires through the Chain (every three

links) and pull the wires until taut.

6. Slip Canopy loop collar (B2) over the chain, then do

the same with the canopy (F2).

Fig 2

PARTS & ASSEMBLY SHEET

Fixture Name: Torbellino 8106-SF CDB

9. Place the Circular Rim (I) over the Glass Shade (L).

10.Take the Nipple/threaded rod(G)and screw into fixture

at (F). tighten in place with hex nut (G).

11. Place the Metal Sleeve (J) and the Cap (K) onto the

Nipple (H), there should be at least 1/2" of threaded rod

exposed above the metal sleeve.

12. Place the Glass shade (L), over the Nipple (H). The

Nipple (H) shall protrude through the bottom hole of the

Glass shade (L).

13. Slide the Rubber Washer (M) onto the Nipple(H).

14. Slide Bottom Cap (P) over Nipple (G) and thread the

Finial (M) until tight.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)

Fig 3

7. When ready to complete the installation Use the other

chain connector and attach the other end of the chain to

the canopy loop (A2) and close the chain connector.

8. Make sure the weight of the chandelier is supported by

the chain-not the electrical wire.

CHAIN