USE AND CARE GUIDE JOANN FLOOR LAMP-#33213 Questions, problems, missing parts? Before returning to the store, call Kenroy Home Customer Service 8 a.m.-6 p.m., EST, Monday-Friday 904-642-4340 THANK YOU We appreciate the trust and confidence you have placed in Kenroy Home through the purchase of this lamp. We strive to continually create quality products designed to enhance your home.
Table of Contents Safety Information ....................................................................................................................................... 2 Warranty ...................................................................................................................................................... 2 Pre-Installation ............................................................................................................................................
Pre-Installation PLANNING INSTALLATION Read all instructions before assembly. To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard. Inspect each part for defects that may have occurred during shipping. Keep your receipt and these instructions for proof of purchase. NOTE: This lamp requires the use of one 120V, 60H z, 6-Watt Edison LED bulb (included) or one 120V, 60Hz, 100-Watt max, medium-base type A bulb (not included).
Assembly instructions 1. Unpack the lamp and assemble the poles □ Carefully organize and place all parts on a smooth, flat surface. line up all of the parts according to the assembly diagram. □ Screw the pole-d (H) to top of the base (I). G □ Screw the pole-c (G) to top of the pole-d (H). H I 2. Assemble the poles □ Screw the pole-b (F) to top of the pole-c (G). □ Screw the pole-a (E) to top of the pole-b (F).
Assembly instructions (continued) 3. Assemble the acrylic strings □ Attach the (20) acrylic strings (C) to the holes of the shade (B) as shown. Hole C B 4. Assemble the shade □ Pull the excess power cord through the base (I). B Notch Ring □ Slide the nipple into notch of ring, then secure the shade (B) to pole-a (E) by tightening the socket assembly (D).
Assembly instructions (continued) 5. Assemble the bulb □ Prior to installing the bulb, inspect socket for silica packet. If packet is present, then remove and throw away. Do not expose it to children or pets. □ Install one 120V, 60Hz, 6-Watt Edison LED bulb (A) (included) or one 120V, 60Hz, 100-Watt max, medium-base type A bulb (not included) into the socket of the light lamp. □ Plug cord into an outlet and turn on at the switch.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
www.kenroyhome.com CUSTOMER SUPPORT TEAM For any additional questions or concerns please contact our Customer Support Team: 904-642-4340 @KenroyHome customerorders@kenroyhome.
