Installation Instructions

Care and Cleaning
□ Clean the lamp with a soft, dry cloth. Do not use any cleaners with chemicals, solvents, or harsh abrasives.
Troubleshooting
Possible Cause
□ The bulb is burned out.
□ The power is off.
□ The circuit breaker is off.
□ There is an exposed wire.
□ There are too many items on
one circuit.
□ Discontinue use of the lamp.
□ Contact a qualified electrician or
call the Customer Service Team at
904-642-4340.
□ Unplug other items on the circuit.
□ Ensure that the circuit breaker
is set in the on position.
□ Ensure that the power supply
is turned on.
□ Replace the light bulb.
Solution
The bulb will not light.
The fuse blows or a
circuit breaker trips when
the light is turned on.
Problem
□ Did not insert plug into power
outlet.
□ Ensure that the plug is fully and
properly inserted into the power
outlet.
Important safety instructions
□ This portable lamp has a polarized plug (one blade is wider than the other) as a feature to reduce the risk
of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified electrician. never use with an extension cord
unless plug can be fully inserted. Do not alter the plug.
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
7