Installation Instructions

ManualsBrandsPhoton Lighting ManualsFlush Mount LightsGreyson Pewter 2-Light Flush Mount Ceiling Light

For Customer Service, contact the place of purchase to arrange for replacement parts.

WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.

HANGING THE FIXTURE (Fig. 1)

1. Carefully remove the new fixture from the carton and the

yellow bag that holds all your parts. Check that all parts are

included as shown in the illustration and parts list.

2. Shut off power at the circuit breaker and remove the old fixture

from wall, including the old mounting strap.

3. Mounting Strap (B) contains several pairs of threaded holes.

Find the pair of holes that matches the holes spacing in your

Canopy (F) and thread the two Mounting Screws (A) halfway into

the Mounting Strap (B).

4. Place the Mounting Strap (B) over the junction box so the

Mounting Screws (A) are vertical.

5. Attach the Mounting Strap (B) to the junction box by using the

two Mounting Screws (C). Tighten the screws securely.

Fig. 1

CONNECTING THE WIRES (Fig. 2)

6. Take the black wire from the ceiling junction box and the

smooth wire leg from the fixture and twist bare ends together.

Twist wire connector onto end of wires until snug.

7. Repeat same process with white junction box wire and ribbed

wire of fixture.

NOTE: Twist wires together in the same direction you twist the

wire connector onto wires.

8. If your junction box has a grounding wire (green or bare

copper), attach this wire and the bare copper wire from the fixture

together as in step 7. If junction box has no ground wire, attach

the bare copper fixture wire to the junction box with a screw.

9. Tuck these wire connections neatly into the junction box.

Fig. 2

INSTALLATION INSTRUCTIONS

Fixture Name: Multi-Family 1270-9/11/13 PW/CH

For Flush Mount Light Fixture

FINISHING THE INSTALLATION (Fig. 3)

10. Place the fixture’s Canopy (F) over the Mounting Strap (B)

and over the Mounting Screws (A). Adjust the fixture canopy until

the Mounting Screws (A) protrude out from the canopy. Secure

the fixture against the ceiling by threading the Decorative Nuts (E)

on until tight.

11. Install the light bulbs and glass shade according to the fixture

assembly sheet.

YOUR INSTALLATION IS NOW COMPLETE. RETURN POWER

TO THE JUNCTION BOX AND TEST THE FIXTURE.

Fig. 3

BARE COPPER

(Ground)

GREEN

(Ground)

FIXTURE WIRES

SMOOTH (BLACK)

RIBBED (WHITE)

BLACK

WHITE

HOUSE WIRES

OUTLET

BOX

(CEILING)