Operation Manual

5.6 Joining an existing network (JoinNet)

If a network already exists, Roger inspiro can simply join

this network.

How to join an existing network:

J Hold Roger inspiro within 10 cm (4 inches) of any

device that is already connected to the network.

J Go to: Network / JoinNet

J Roger inspiro will join the existing network.

5.7 Creating a new network ID (NewNet)

To create a new network within the same operating

range (i. e. room or department) as an existing network,

it is necessary to create a new network ID.

I Creating a new network ID will erase all the existing

network data in your Roger inspiro and there is no

way to revert back to the previous network ID.

How to create a new network ID:

J Go to: Network / Create NewNet