EU Representative: Phonak GmbH D-70736 Fellbach-Oeffingen Germany www.phonak.com/roger 029-3166-02/V1.
User Guide
Contents 1. Welcome 5 2. Getting to know your Roger MyLink 6 2.1 Compatibility 7 2.2 Device description 7 2.3 Indicator light 9 3. Getting started 14 Step 1. Charge your Roger MyLink 14 Step 2. Detach the neckloop 16 Step 3. Hang Roger MyLink around the neck and reattach the loop 16 Step 4. Switch Roger MyLink on 17 Step 5. Choose how to wear Roger MyLink 17 Step 6. Turn on your Roger microphone 18 Step 7.
. Using headphones Step 1. Plug the headphones into Roger MyLink’s headphone socket 21 21 Step 2. Turn Roger MyLink on 21 Step 3. Put the headphones on 22 5. More detailed information 23 6. Troubleshooting 24 7. Important information 26 7.1 Hazard warnings 26 7.2 Product safety information 28 7.3 Other important information 31 7.4 International use 32 8. Service and warranty 33 9.
1. Welcome Congratulations on choosing Roger MyLink from Phonak. Roger MyLink is an easy-to-use and affordable Roger receiver suitable for use with any hearing aid featuring a T-Coil (from Phonak or any other manufacturer). Roger MyLink is compatible with most Roger microphones from Phonak. Your Roger MyLink is a Swiss premium-quality product developed by Phonak, the world’s leading hearing healthcare company.
2. Getting to know your Roger MyLink Your hearing system consists of three main elements: Roger MyLink, your hearing aids and a Roger microphone, such as Roger inspiro. The Roger microphone transmits the speaker’s voice wirelessly to your hearing aids via the Roger MyLink. You only need to activate the T-Coil in your hearing aid(s) to hear the speaker’s voice loud and clear in your ear(s).
2.1 Compatibility Your hearing aids must feature a T-Coil to receive speech signals from Roger MyLink. Please ask your hearing care professional if you are unsure whether or not your hearing aids have a T-Coil. A compatible Roger microphone is also required to pick up the voice of the speaker. In this User Guide, Roger inspiro is used as an example. 2.
2. Getting to know your Roger MyLink a Volume control b On/off a b a Charging socket b Headphone socket (2.
2.
2.
Meaning User action Roger MyLink has been switched on and is ready for use. Switch on the Roger microphone and set the hearing aids to the T-Coil program. Battery is almost empty. Charge Roger MyLink as soon as possible (within an hour).* Battery is completely exhausted. Roger MyLink can no longer be used without first being charged. Roger MyLink will automatically switch off after ten flashes. Charge Roger MyLink immediately (within an hour).
2.
Meaning User action Roger MyLink is connected to the charger and is being charged. Wait until battery is charged. Charging a completely exhausted battery takes around two hours. The battery will be 80% charged within one hour. Roger MyLink’s battery is fully charged. Unplug the charger. The green light will disappear, meaning Roger MyLink is ready for use. The volume control is set to either maximum or minimum position. The volume control is in the middle position.
3. Getting started Step 1. Charge your Roger MyLink Fully charge Roger MyLink and your Roger microphone before using the system for the first time. An empty Roger MyLink battery is: J 80% charged after one hour J 100% charged after two hours Plug the charging unit into an easily accessible power socket. ! Only use original Phonak charging units.
Plug the connector from the charger into the Roger MyLink charging socket. J Once fully charged, Roger MyLink can be used for 10 or more hours. J Roger MyLink cannot be used when the charger is still attached.
3. Getting started Step 2. Detach the neckloop Step 3.
Step 4. Switch Roger MyLink on Step 5.
3. Getting started Step 6. Turn on your Roger microphone Step 7. Switch your hearing aids to the T-Coil program I It may be necessary to contact your hearing care professional to enable the T-Coil program in your hearing aids. Step 8. Connect Roger MyLink to your Roger microphone Hold Roger MyLink within 10 cm / 4 inches of your Roger microphone and press Connect on the Roger microphone.
I Step 8 is only required the first time you use Roger MyLink. Roger MyLink will then remain connected with your microphone even after Roger MyLink has been rebooted.
3. Getting started Step 9. Adjust Roger MyLink’s volume Volume up Volume down Short button press: The volume will increase / decrease only slightly. Long button press: The volume will continue to increase / decreased until you stop pressing the button. Once you have chosen your preferred volume, Roger MyLink will automatically store this setting for next time. I If the wirelessly transmitted signal is not strong enough, increase the volume setting on Roger MyLink.
4. Using headphones People who do not wear hearing aids can use Roger MyLink with headphones. To benefit from maximum hearing comfort, we recommend using official Roger MyLink headphones. Step 1. Plug the headphones into Roger MyLink’s headphone socket Step 2.
4. Using headphones Step 3. Put the headphones on J The neckloop is automatically switched off when the headphones are attached (to save battery power). J Use Roger MyLink’s volume control to increase or decrease the volume of the transmitted signal (see page 20).
5. More detailed information Operating range: Up to 20 meters / 66 feet Battery: Rechargeable Lithium-Polymer accumulator Power supply: 7.5 VDC / 250 mA Wireless: 2.
6. Troubleshooting The following is a summary of frequently asked questions about Roger MyLink and our answers to them.
Most probable cause Solution The signal is interrupted during audio streaming J Roger MyLink is too far away from the Roger microphone J Move closer to the Roger microphone to move within its operating range J Roger MyLink is shielded by an obstacle (e.g.
7. Important information R Please read the information on the following pages before using your Phonak Roger MyLink. 7.1 Hazard warnings ! Persons with pacemakers or other medical devices should ALWAYS consult their physician, the manufacturer of their device BEFORE using the Roger MyLink. The use of Roger MyLink with a pacemaker or other medical devices should ALWAYS be in accordance with the safety recommendations of the physician responsible for your pacemaker or the pacemaker manufacturer.
! Opening the Roger MyLink might damage it. If problems occur that cannot be resolved by following the guidelines in the Troubleshooting section of this User Guide, consult your hearing care professional. ! Your Roger MyLink should only be repaired by an authorized service center. Changes or modifications to this device that were not explicitly approved by Phonak are not permitted. ! Please dispose of electrical components in accordance with your local regulations.
7. Important information ! Only use accessories that are approved by Phonak AG. ! When operating machinery, ensure that no parts of your Roger MyLink can get caught in the machine. ! Do not charge Roger MyLink while it is on your body. ! Caution: electric shock. Do not insert plug alone into electrical outlets. 7.
I Protect the Roger MyLink from excessive shock and vibration. I Do not expose your Roger MyLink to temperatures and humidity outside of the recommended conditions stated in this User Guide. I Do not use excessive force when connecting your Roger MyLink to its different cables. I Protect all openings (microphones, audio input and charger) from dirt and debris.
7. Important information I Clean the Roger MyLink using a damp cloth. Never use household cleaning products (washing powder, soap, etc.) or alcohol to clean the Roger MyLink. I Only recharge your Roger MyLink using chargers supplied by Phonak or by stabilized chargers providing 5VDC and ≥500 mA. I When the Roger MyLink is not in use, turn it off and store it safely. I The Roger MyLink has a built-in rechargeable battery.
7.3 Other important information J High-powered electronic equipment, larger electronic installations and metallic structures may impair and significantly reduce the Roger MyLink’s operating range. J Roger MyLink collects and stores internal technical data. This data may be read by a hearing care professional in order to check the device, as well as to help you use your device correctly.
7. Important information J Avoid exposing the receiver to hair spray or other cosmetic chemicals. J The sensitivity of the hearing aid microphone may be reduced by the use of your Roger MyLink and therefore environmental awareness may be reduced. 7.4 International use J The Roger MyLink is operating in the 2.4GHz ISM Band, which is unlicensed and worldwide available.
8. Service and warranty 8.1 Local warranty Please ask the hearing care professional, where you purchased your Roger MyLink, about the terms of the local warranty. 8.2 International warranty Phonak offers a one year limited international warranty, valid as of the date of purchase. This limited warranty covers manufacturing and material defects. The warranty is valid only if proof of purchase is shown.
8. Service and warranty 8.3 Warranty limitation This warranty does not cover damage from improper handling or care, exposure to chemicals, immersion in water or undue stress. Damage caused by third parties or non-authorized service centers renders the warranty null and void. This warranty does not cover any services performed by a hearing care professional in his/her office.
9. Information and explanation of symbols C With the CE symbol, Phonak AG confirms that this Phonak product meets the requirements of the Medical Devices Directive 93/42/EEC as well as the R&TTE Directive 1999/5/EC on radio and telecommunications equipment. π This symbol indicates that Roger MyLink products meet the requirements of a Type BF component containing EN 60601-1.
9. Information and explanation of symbols ! This symbol indicates that it is important for the user to pay attention to the relevant warning notices in these user guides. I Important information for handling and product safety. E Australian EMC and Radiocommunications compliance label. Operating conditions This device is designed such that it functions without problems or restrictions if used as intended, unless otherwise noted in these user guides.
Transport and storage conditions During transport or storage, the temperature should not exceed the limit values of –20° to +60° Celsius (–4° to +140° Fahrenheit) and relative humidity of 90% for a long period of time. The air pressure between 500 hPa and 1100 hPa is appropriate.
T 38 The symbol with the crossed-out garbage bin is to make you aware that this device may not be thrown away as normal household waste. Please dispose of old or unused device, at waste disposal sites intended for electronic waste, or give your device to your hearing care professional for disposal. Proper disposal protects the environment and health. This product has an embedded, nonreplaceable battery.
