Installation Instructions

ManualsBrandsPhonak ManualsHearing aidsDynamic SoundField

Installation instructions

Dynamic SoundField

Follow these installation instructions carefully to make sure your Dynamic SoundField system is properly installed.

Dispose of the packaging material as per local regulations.

The following materials are included (if any are missing, contact your local Phonak dealer):

DigiMaster 5000/7000 package

Wall support (1x) Array ﬁxation (1x)

Power adapter and power cable

(delivered in DigiMaster 5000)

OPTION

DigiMaster

loudspeaker (1x)

Torx-screws (4x)

Anchors (4x)

Clamps (2x)

Hex-screws (2x)

Torx screwdiver T20 (1x)

and hex wrench 5 (1x)

and hex wrench 6 (1x)

OPTION OPTION

Summary of content (7 pages)

PAGE 1
Installation instructions Dynamic SoundField The following materials are included (if any are missing, contact your local Phonak dealer): DigiMaster 5000/7000 package A V5.
PAGE 2
Installation instructions Dynamic SoundField Optional: Standard ‘DigiMaster Floor Stand’ including: Box (1x) Stand plate (1x) Tube connection (1x) Stand tube (1x) Torx screwdiver T20 (1x) and hex wrench 5 (1x) and hex wrench 6 (1x) Hex-screws (2x) V5.
PAGE 3
Installation instructions Dynamic SoundField The following tools are required for the installation: To mount the loudspeaker on the floor stand: Hex wrench 5 Hex wrench 6 1. Selecting the right location 1) I dentify an open and safe place, ideally in front of the class, e. g. on the right or left side of the whiteboard or blackboard.
PAGE 4
Installation instructions Dynamic SoundField 2. Installation 2.1 Mounting the DigiMaster on its stand 1) T ake the assembled stand plate, stand tube, black M8 screw and M8 washer. 4) Push two black hex screws into the upper part of the stand tube. Screw the DigiMaster featuring the tube connection to the tube using hex wrench 5. 2) G ently place the ‘screw thread’ end of the tube stand in the center of the plate (see picture below). The three holes are on the upper side of the stand.
PAGE 5
Installation instructions Dynamic SoundField 2.2 Mounting DigiMaster on the wall 1) M easure 1.40 meters (4 feet) up from floor level and mark this point on the wall with a pencil. Hold the wall support against the wall so that the pencil mark is at the bottom of the wall support. Adjust the wall support using the spirit level until it is level. Use the pencil to mark the wall through the wall support’s four holes.
PAGE 6
Installation instructions Dynamic SoundField 3. Pairing DigiMaster with inspiro 1) Make sure inspiro is fully charged (see Dynamic SoundField User Guide). Switch on inspiro. 2) Follow the pairing procedure relevant to your inspiro’s software version: inspiro version 3.0 and later inspiro version 2.2 – 2.3 When the battery symbol appears, press ‘pairing’ soft key button. inspiro will guide you through the pairing process. Please follow the on-screen instructions.
PAGE 7
Installation instructions Dynamic SoundField 6) S etting up a MultiTalker Network when using a DigiMaster loudspeaker Pre-requisite: All secondary inspiros for MTN should not be paired with any DigiMaster loudspeaker! Before setting up MTN, select each inspiro’s ‘SoundField’ menu then ‘Disconnect’. 1) First pair the initiator inspiro transmitter with the DigiMaster loudspeaker. Select ‘SoundField’ menu then ‘Pairing’. V5.