Phx SD Manual 13

First Time After Storage Checklist
SAFETY
Prior To Use
Listed below are steps to follow each time you use
your grill. If this is the first time, be sure you read
and understand all information in this manual.
-Your grill parts have been coated with a preserv-
ative to prevent rust. Prior to the first use, it is im-
portant that the grill be lit and allowed to operate
on “HIGH” for at least 15 minutes with the lid
closed before any food is placed on the cooking
surface.
-If the grill has been moved or cleaned, be sure
the venturis are properly located. The valve out-
lets MUST be inside the venturis. Improper posi-
tioning could cause property damage or personal
injury. (See Picture on Page 5.)
-Be sure all gas connections are free from leaks.
(See “Leak Testing” procedure).
-Be sure any electrical supply cords and/or any
fuel supply hoses are kept away from hot surfac-
es.
-Be sure to periodically clean the venturis. (See
“Care and Maintenance” for cleaning procedure).
-Be sure ventilation openings of the cylinder en-
closure are kept clean and clear of debris.
-Do not move the grill when lit.
WARNING
NEVER Move Grill After It Is Lit.
Natural Gas Precautions
If your Phoenix Grill has been converted to natural
gas by an authorized Phoenix Grill Distributor then
please follow the precautions described hereafter.
Caution:
The outdoor cooking gas appliance and its in-
dividual shutoff valve must be disconnected from
the gas supply piping system during any pressure
testing of that system at test pressures in excess
of 1/2 PSI (3.5 KPA).
Beware of Spiders
An obstructed venture tube is not the only cause
of “Flashback”, it is the most common cause.
There, to avoid this problem, frequent inspection
and cleaning of the venture tubes is neces-
sary, even before the first operation of the
grill. Failure to do so may result in a fire be-
neath your grill. See (Care and Maintenance
Section” for proper procedure to ensure clean
venture tubes.
-Have you completed the “Leak Test” procedure?
If not, do so before attempting to light grill.
-Be sure you have followed the “Prior to Use” and
all safety instructions before lighting grill.
-Open grill top before lighting. NEVER light grill
with top down.
-Make sure that control knobs are on “OFF”.
-Turn the gas supply on at the propane cylinder.
Ignitor and Match Lighting Procedure
12
In some areas of the country, spiders and small
insects have been known to spin webs or make
nests inside of the venture tubes. These webs can
lead to gas flow obstruction which could result in a
fire in and around the venture tubes. This type of
fire is commonly known as a “Flashback”, and can
cause serious damage to the grill and create an
unsafe operating condition for the user. Although
Push-button Lighting Procedure:
1. Push in and turn either left or right control knob
to “HI”.
2. Immediately push igniter button all the way in
until ignition is heard, then release. Check through
center peep hole to verify ignition has taken place.
Adjust burner knobs to desired heat setting.
3. If ignition does not occur within 5 seconds turn
burner control(s) off. Wait 5 minutes and repeat
lighting procedure.
Match Lighting Procedure:
You may also elect to use a match to light your
grill. Place a match in the hole left of the drip pan
valve, then push in and turn the right control knob
to “HI” until you see the gas is lit through the
peephole located just above the control knobs.
Then follow steps 3 and 4 above.
IMPORTANT: If the burner flame goes out when
the unit is in use, always turn gas control knobs to
“OFF” immediately. Open grill lid and wait 5
minutes before relighting.
Always turn off the gas supply at the propane tank
valve when the grill is not in use.
SAFETY LIGHTING