Owner's Manual

9
CONTINUE
Step 3: Attaching Control Panel to Grill Pit.
A. Thread on the push button to the igniter stem. (Fig. H)
B. Attach the igniter probe wire (preassembled at factory to the gas
collector box) to the electronic spark generator. (Fig. I)
C. Attach the control panel to the front of pit by pushing the two
threaded studs thru the holes in the bottom of the pit, making
sure the venture tubes fit over the valve orifices and secure with
2, flat washers and 2, 1/4” Kep nuts. (Fig. J-1)
D. Attach the bottom of the control panel to column using 2 1/4-20 x
1/2” hex head bolts , 4 flat washers and 2 Kep nuts. Press the 2
gas control knobs onto the valve stems. (Fig. J-2)
Igniter Wire
Fig. J-2
Step 4: Attaching Side Shelves
A. Remove white film from side shelves and grill.
B. Attach brackets to grill using bolts and kep nuts to each side of
your grill as shown in (Fig. K-1) Use 2 bolts and kep nuts per
bracket.
C. Place the left bottom shelf post into the left bottom bracket slot as
shown in (Fig. K-2). Gently spread the shelf apart to insert the
right bottom shelf post into the right bottom bracket slot. Secure
bottom posts with Nylock Nut—making sure nuts are snug but do
not restrict the movement of folding and unfolding of the shelf.
Note: Top posts on shelf do not use nuts.
Fig. K-1
Step 5: Lid Assembly to Fire Pit
A. Position the top and bottom hinges together and
complete assembly using the two (2) hinge pins and hinge
clips. (Fig. L)
B. With the lid open attach the handle to the lid using two 1/4-20 x 3/4” hex
bolts, flat washers, graphite gaskets, and Kep nuts. The gaskets are
positioned between the handle end caps and grill lid. (Fig. M)
C. Install the thermometer through the hole in the center of the lid.
And snug thermometer with thumb bolt. Do Not Over Tighten.
Hinge Clip
Hinge Pin
Step 6: Install Drip Pan and Drain Valve
A. With the lid open, insert drip pan into place using the lift tabs on
each end. Line up the drain pipe with the hole in the pit bottom and
make sure the drain pipe extends out the bottom of the pit. Install
the brass valve onto the drain pipe, hand tighten only. (Fig. O)
(You may need to remove the valve occasionally for cleaning.
Hang the drain bucket on the brass valve and open valve. (Fig. P)
Fig. L
Fig. N
Brass Valve
Drain Pipe
Fig. O
Step 7: Install Cooking Grid
A. Place the cooking grid into the grill.
Fig. H
Fig. I
Fig. J-1
Fig. K-2
Fig. M
Graphite Gasket
Fig. P