Owner's Manual

8
Grill
Hex Headl
A. Attach the front (center) section of the column to the base using
2, 1/4-20 x 1/2” hex head bolts, 4 flat washers and 2 Kep nuts.
(Fig. A)
B. Attach the two (2) sides of the column to the base using 4, 1/4-20
x 1/2” hex head bolts, 8 flat washers and 4 Kep nuts. (Fig. B)
NOTE: Washers should be placed
after the hex head and before the
Kep nuts. Follow through-out as-
sembly.
C. Attach sides of col umn sections
using 6 1/4-20 x 1/2” hex
head bolts, 12 flat washers and 6 Kep nuts.
D. Insert heat shield into top of column using 8 1/4-20
X 1/2” hex head bolts, 16 flat washers and 8 Kep
nuts. (Fig. D)
E. Lay base on its side and bolt caster into place with
Bolts at all 4 corners of base.
(Fig. E)
F. Attach the tank lock bar across the back of the col
umn. Use the 3/4” Hex bolt, 4 Flat Washers, Nylon
Spacer and the Kep nut on each side to fasten the
bar in place. (Fig. E-1)
Fig. A
Fig. B
Heat Shield
Fig. D
Fig. E
Step 2: Mounting Grill Fire Pit to Column.
A. Set the grill pit onto the top of the column and align the 6 pit
mounting holes to the matching holes in the column lip.. Install
the 6 hex bolts, 12 washers and 6 Kep nuts. Tighten securely.
(Fig. F)
Fig. F
Step 3: Attaching Control Panel
to Grill Pit.
Threaded Studs
NOTE: The control panel has two (2) threaded studs
with a spacer nut that mounts to the fire pit allowing
airflow between the pit and control panel. Also, the
control panel comes with factory preassembled gas
regulator, hose and igniter. (Fig. G)
Fig. G
Step 1: Mounting Column to Base.
Flat Washers
Kep Nut
Tank Locking Bar
Propane Model
Nylon Spacer
Hex Bolt
Kep Nut
Fig. E-1
Flat Washer
Grill
Fig. E