Owner's Manual

ManualsBrandsPhoenix ManualsGrills54 Inch Stainless Steel Freestanding Grill

Phoenix Grill Assembly Instructions

Carton contains the following components for assembly:

Please check to be sure that all parts are included before proceeding.

Contact your dealer or the factory if any parts are missing.

Grill and Cart Components

Grill Lid 1

Grill Bottom with Pre-Assembled Burner, Gas

Collector Box and Igniter Wire

Hinge Pins and Clips 2 Each

Column 3 (Front, 2 Sides)

Tank Locking Bar (See Pre-Pack Below)

(Propane Model)

1 Pre-Pack

12 Ft. Hose with Quick Disconnect

(Natural Gas Model)

Base 1

Locking Casters 4

Control Panel with Pre-Assembled Valve,

Hose, Regulator and Igniter

Burner Control Knobs 2

Electronic Igniter 1

Temperature Gauge 1

Shelf Brackets, Shelves

(See Pre-Pack Below)

1 Pre-Pack

Stainless Steel Handle, Handle End Caps

(See Pre-Pack Below)

1 Pre-Pack

Cast Aluminum Drip Pan 1

Stainless Steel Cooking Grid 1

Drip Pan Drain Valve 1

Collector Bucket 1

Heat Indicator 1

Hardware/Fasteners

HARDWARE QUAN. USE

1/4-20 x 1/2” Hex Head Bolt 12 Column to Base

KEP Nut 12 Column to Base

1/4-20 x 1/2” Hex Head Bolt 8 Heat Shield to Column

KEP Nut 8 Heat Shield to Column

1/4-20 x 1/2” Hex Heat Bolt 6 Grill Bottom to Column

KEP Nut 6 Grill Bottom to Column

KEP Nut 2 2 Threaded Studs on

1/4– 20 x 1/2” Hex Head Bolt 2 Control Panel to Column

KEP Nut 2 Control Panel To Column

Hinge Pin 2 Lid to Grill Bottom

Hinge Clip 2 Lid to Grill Bottom

1/4-20 x 1/2” Hex Head Bolt 16 Casters to Base

Phillips and Straight Screw Driver

7/16 Socket or Nut Driver

7/16 Wrench

Pre-Packaged Part and Fasteners

Tank Locking Bar- Nylon Spacer, 2 -3/4” Hex Bolt, Flat Washers (4) and Kep

Nuts (2)

Handle– Handle End Caps (2), Graphite Gasket (2), Hex Bolts (2), Flat Wash-

ers (4) and Kep Nuts (2)

Shelf Assembly– Shelf Brackets (4), Shelves (2), Hex Head Bolts (8), #10

Lock Washer (8), 10/24” x 1/2” Pan Head (8), Nylon Lock Nuts

(8),and Kep Nuts (8)

Fastener Totals

Hex Bolts 1/4-20x1/2 ........................................................................52

Kep Nuts............................................................................................42

Hex Bolts 1/4-20x3/4...........................................................................4

Pan Head 10-24 x 1/2”……………………………………………………8

Nylon Lock #10…………………………………………………………….8

Lock Washer #10…………………………………………………………..8

TOOLS NEEDED FOR ASSEMBLY