Owner's Manual

Step 3: Axle and Wheel Assembly
1. Install (1) axle hitch pin into the small end hole of
the axel. Slide (1) wheel onto the axle, hubcap
side out.
2. Slide open axle end through the short leg holes
and install remaining wheel, washer and hitch
pin. Install hubcaps after the cart bolts are com-
pletely tightened.
3. Stand grill upright to seat legs and tighten all
bolts and nuts making legs and frame rigid.
Note: Recheck all fasteners for tightness.
Step 2: Installing LP Tank Fastener
1. Located on the underside of grill pit, mount the
LP tank fastener to the underside of the heat
shield with 2 10-24 Pan Head Blots as shown in
(Fig. 7).
2. Secure the LP tank fastener from the inside of
the heat shield with two 10-24 Kep nuts as
shown in (Fig. 8) and tighten with wrench.
Fig. 7
Fig. 8
Step 4: Installing the Drop Down Shelves
Mounting Bracket to Grill
1. Attach brackets to grill using bolts and kep nuts
to each side of your grill as shown in (Fig. 10)
Use 2 bolts and kep nuts per bracket.
Fig. 9
Fig. 10
Fig. 11
Mounting Shelf to Bracket
2. Place the left bottom shelf post into the left bot-
tom bracket slot as shown in (Fig. 11). Gently
spread the shelf apart to insert the right bottom
shelf post into the right bottom bracket slot. Se-
cure bottom posts with Nylock Nut—making
sure nuts are snug but do not restrict the move-
ment of folding and unfolding of the shelf.
Note: Top posts on shelf do not use nuts.
Shelf Brackets
OPENING SHELF
LOCK INTO PLACE