Owner's Manual

Complete View of Cart Assembly
1/4-20 x 1/2” Carriage 1
Hub Caps 2
Hose Retaining Ring 1
1/4-20x1/2” Truss Head 18
1/4-20x3/4” Hex Head 10
1/4-20 Kep Nut 28
10-24x1/2" Pn..Hd. 11
10-x24 Kep Nut 11
10-24 Nylon Lock Nut 8
Short Legs
Hose Ring
Long Legs
Lower
Cart Frame Bolts to
Each Leg
FIG. 1
Long Legs 2
Short Legs 2
Lower Frame Brackets 2
Lower Tank Brackets 2
8" Rubber Wheels 2
Axle 22 1/2" 1
Axle Hitch Pins 2
LP Tank Fastener 1
1/4—20 Wing Nut 1
CART HARDWARE
Carton contains the following components for the cart mount-
ing:
Please check to be sure that all parts are included before proceed-
ing. Contact your dealer or the factory if any parts are missing.
SDRIV4LDD Cart Assembly
Tools Required For Assembly:
7/16” Wrench, 7/16” Socket Wrench with Extension, 3/8”
Wrench.
CAUTION: Edges of some of the grill parts may be sharp,
use care when assembling grill.
CAUTION: While handling the grill head be very careful not
to damage the Venturi Tubes or the Ceramic Ignitor Insulator
which protrudes from below the grill.
Step 1: Leg Assembly (Fig 2)
1. Tip the grill head bottom on end as shown in Fig. 2
(TIP: work on protected area such as carpet, tarp or one
of the boxes to protect grill finish.)
2. Attach the two long legs to the right end of the grill’s bot-
tom pit. Use two 10-24 x 1/2” Pan Head Bolts for each
leg. Insert bolts from outside of grill pit and fasten with 10
–24 kep nuts.
3. Flip the grill over and attach the 2 short legs to the left
side of the grill pit bottom. Use two 10-24 x 1/2” Pan
Head Bolts for each leg. Insert bolts from outside of grill
pit and fasten with 10-24 kep nuts. Note: When attach-
ing front legs make sure the control panel tab is
tucked behind the front legs as shown in (Fig. 3) The
valve stems must be seated properly in the venturi
tubes as shown in (Fig. 4) before tightening.
4. Flip grill upside down and attach the lower shelf brackets
to the front and back of the grill with four 1/4-20x1/2” Hex
Head Bolts for each bracket as shown in (Fig. 5).
5. Next attach the lower tank brackets from front to back to
the lower frame brackets as shown in (Fig. 6)Note: An-
gled edges face out.
6. Tighten all fasteners with wrench before moving on to
next steps.
FINGER TIGHTEN ALL BOLTS UNTIL
LOWER BRACKETS ARE ATTACHED.
Fig. 2
Fig. 3 Fig. 4
Fig. 5
Fig. 6
PEEL ALL LASER TAPE BEFORE ASSEMBLING