User manual

Configuration and Diagnostics
6874_en_09 PHOENIX CONTACT 4-21
"Configuration Management/General" Menu
This table is used to view all parameters that are required to save the active configuration
or load a new configuration, and to modify them (by entering a valid password). It can also
be used to restart the system with the relevant configuration.
Figure 4-23 "Configuration Management" web page
Possible States for "Status of current configuration":
– The configuration has been modified but not saved (also indicated by the flashing
floppy disk icon).
– Saving the current configuration.
– The current configuration is equal to the one saved in the non-volatile memory of the
switch.
– The current configuration was saved.
Save current
configuration
The active configuration together with the corresponding configuration name can be saved
here by entering a valid password.
Figure 4-24 "Save current configuration" web page
Set default upon delivery This option can be used to reset the switch to its default settings (default upon delivery) by
entering a valid password.
Figure 4-25 "Set default upon delivery" web page
If the new configuration is not activated by a reset after a configuration download, the
"Save current configuration" command overwrites the previously loaded configuration
and instead saves the active configuration of the MMS.
WBM can only be called using a valid IP address. Once the switch has been reset to its
default settings, it has no valid IP address and the addressing mechanism is set to
BootP.