User manual

FL SWITCH MM HS
3-26
PHOENIX CONTACT 6874_en_09
3.2.9.4 Connecting the 48 V PoE Supply Voltage
Connecting the PoE Supply
The connector for the PoE supply is located on the bottom of the interface module. Please
observe the keying on the connector when inserting it.
The module has a green LED for each port, which indicates the PoE mode. The LED is
active if the PoE supply and a PD (powered device) are connected. The LED flashes if the
module is supplied with less than 48 V.
Figure 3-16 Connecting the PoE voltage connector
1
2
1
2