User manual

Startup and Functions
6874_en_09 PHOENIX CONTACT 3-1
3 Startup and Functions
3.1 Basic Settings
3.1.1 Default Upon Delivery/Default Settings
By default upon delivery or after the system is reset to the default settings, the following
functions and properties are available:
– The password is "private".
– All IP parameters are deleted. The switch has no valid IP parameters:
IP address: 0.0.0.0
Subnet mask: 0.0.0.0
Gateway: 0.0.0.0
– BootP is activated as the addressing mechanism.
– All available ports are activated with the following parameters:
- Auto negotiation.
- 100 Mbps - full duplex for FX glass fiber modules and HCS ports.
– All counters of the SNMP agent are deleted.
– The web and Telnet server, SNMP agent, and V.24 (RS-232) interface are active.
– Port mirroring, Rapid Spanning Tree, access control for web interface, port security,
multicast filtering, VLAN, DHCP relay agent option 82, and LLDP are deactivated.
– Port security is deactivated for all ports.
– Access control for WBM is deactivated.
– The alarm contact only opens in the event of non-redundant power supply and a
detected PoE error.
– The transmission of SNMP traps is deactivated and the switch has no valid trap
destination IP address.
– The aging time is set to 40 seconds.
– The switch is in "Default" mode.
– The WBM refresh interval is set to 30 seconds.
– Management is in VLAN 1.
The basic Ethernet functions do not have to be configured and are available when the
supply voltage is switched on.
The aging time is set using the "dot1dTpAgingTime" MIB object
(OID 1.3.6.1.2.1.17.4.2). The available setting range is 10 - 825 seconds. For static
configuration, an aging time of 300 seconds is recommended.
During switch restart, the active configuration including IP parameters is written to a
plugged-in memory module.