User manual

FL SWITCH MM HS

2-4

PHOENIX CONTACT 6874_en_09

Removal:

1. Remove all plug-in connections or interface modules.

2. To release the plug-in connection for the system interface, insert a screwdriver in the

notch provided and use it to push the modules apart.

3. Push the right-hand extension module along the DIN rail to the right until the plug-in

contact is completely free.

4. Pull down the holding latches using a suitable tool (e.g., screwdriver).

5. Then swivel the bottom of the module away from the DIN rail slightly (A). Next, lift the

module upwards away from the DIN rail.

Figure 2-5 Removal of extension modules

Switch off the supply voltage before removing the extension modules.