User manual

FL SWITCH MM HS
4-80
PHOENIX CONTACT 6874_en_09
Description Here you can disable the port:
Port disabled 1
Port enabled 2
flWorkNetPortLinkMonitoring
OID 1.3.6.1.4.1.4346.11.11.4.2.2.1.8
Syntax Integer
Access Read and write
Description This object can be used to enable link monitoring (message via display and alarm contact)
for the relevant port:
Link monitoring enabled 2
Link monitoring disabled 1
flWorkNetPortModus
OID 1.3.6.1.4.1.4346.11.11.4.2.2.1.9
Syntax Integer32 (0 - 1024)
Access Read and write
escription This object can be used to set the transmission mode for the relevant port:
Auto negotiation 1
10 Mbps half duplex 2
10 Mbps full duplex 3
100 Mbps half duplex 4
100 Mbps full duplex 5
flWorkNetPortSTPEnable
OID 1.3.6.1.4.1.4346.11.11.4.2.2.1.10
Syntax Integer
Access Read and write
Description This object controls the handling of BPDUs if (Rapid) Spanning Tree is activated:
Firmware with Rapid Spanning Tree Protocol:
RSTP not activated 1
RSTP activated 2
Firmware with Spanning Tree Protocol:
STP not activated (port is in:
Fast forwarding mode 1
STP activated 2
flWorkNetPortIfIndex
OID 1.3.6.1.4.1.4346.11.11.4.2.2.1.11
Syntax Integer32 (0 - 1024)
Access Read
Glass fiber FX ports only support operation at 100 Mbps full duplex (5).
The auto crossing function is only active when auto negotiation is enabled. If
the transmission speed or transmission mode is set to a fixed value, the auto
crossing function is disabled.