Manual

CLEANING

PISTOL SHOULD BE CLEANED AS SOON AS POSSIBLE AFTER FIRING. BEFORE

ATTEMPTING TO CLEAN PISTOL, EMPTY CHAMBER AND MAGAZINE OF ANY

AMMUNITION AND REMOVE ALL AMMUNITION FROM CLEANING AREA. COVER WORK

AREA WITH OLD NEWSPAPER. IT IS BEST TO REMOVE BARREL FOR clEANING.

ASSEMBLE KNOB ROD AND BRUSH. PLACE A FEW DROPS OF "BREAKFREE CLP" TO

ROD AND BRUSH. INSTALL BRUSH INTO BORE FROM CHAMBER END AND WORK

BACK AND FORTH 5 TIMES. ALLOW OIL TO PENETRATE FOR ABOUT FIVE MINUTES.

WORK BRUSH BACK AND FORTH 10 TIMES TO LOOSEN STREAKS OF LEAD AND

FOULING. ATTACH OIL SOAKED PATCH TO SLOTTED END AND WORK BACK AND

FORTH 10 TIMES. PLACE DRY PATCH ON JAG END AND PUSH THROUGH BORE.

REPEAT UNTIL PATCH COMES OUT CLEAN. USING A LIGHTLY OILED PATCH AND

SLOTTED END. OIL BARREL BORE AND ALLOW TO CURE FOR AT LEAST TWO HOURS.

OTHER AREAS OF PISTOL SHOULD BE CLEANED FROM FOULING WITH A SOFT

CLOTH. AND OILED LIGHTLY.

"BREAKFREE CLP"

BRUSH

1 1

)::

00 ,

~JAGEND

~ .

SLOTTED

END

KNOB

~PATCHES

~SCREW