OPERATING INSTRUCTION MANUAL MODELS HP22 , HP25 Be HP22A . Be HP2'pA ~"\'~.
PHOENIX ARMS@ DELUXE AT HOME ON THE RANGE RANGE KIT
PURSUANT To STATE OF CALIFORNIA P.C. 12088.6 A CHILDREN ARE SEVERE INJURIES LOCKED AWAY FIREARM WHERE OR TO SENT ATTRACTED OR AND TO AND DEATH. OBTAINS LOS AND NINOS SIEMPRE USTED NINOS CON TlENE ACCESO ENVIARLO LOS ELLOS LOS A FIREARMS ACCESS NOT IN THAT BY ALWAYS USE. IMPROPERLY IF YOU USES CAN CAUSE KEEPING KEEP IT, YOU A GUNS LOADED MAY BE FINED PRISON. FUNCIONAR.
! DANGER Do NOT STORE, CARRY, DROP, DRIVE A VEHICLE, BICYCLE, WALK OR RUN WITH A LIVE ROUND IN THE CHAMBER. A GUN THAT IS DROPPED, BUMPED OR 'JARRED WITH A LIVE ROUND IN THE CHAMBER MIGHT ACCIDENTALLY DISCHARGE, EVEN WITH THE SAFETY ON, CAUSING INJURY TO YOU OR SOMEONE ELSE. ALWAYS WEAR PROPER SHOOTING FROM FLYING PARTICLES. ALWAYS USE TO REPEATED GLASSES TO PREVENT HEARING PROTECTION TO PREVENT EXPOSURE TO GUN FIRE NOISE.
A NEVER Do DEPEND WARNING ON ANY FIREARMS SAFETY NOT ALTER ANY OF COMPONENTS IF THE TRIGGER POSITION, THIS BARREL! DEVICE, USE CAUTION. OF THIS PISTOL. IS PULLED WHILE THE SAFETY IS IN THE PISTOL WILL FIRE ANY CARTRIDGE LEFT "FIRE" IN THE AMMUNITION USED IN THIS FIREARM CONTAINS LEAD. THE USE OF THIS AMMUNITION MAY EXPOSE YOU TO LEAD, A CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, AND REPRODUCTIVE HARM.
A CAUTION Do NOT PUT AMMUNITION INTO THIS PISTOL, OR MAGAZINE, UNTIL YOU HAVE READ THESE INSTRUCTIONS AND FULLY UNDERSTAND ALL FUNCTIONS AND SAFE HANDLING OF THIS PISTOL. Do NOT ATTEMPT TO USE THIS FIREARM UNTIL YOU HAVE COMPLETELY READ THIS MANUAL. A THOROUGH UNDERSTANDING OF THIS PISTOL AND ITS SAFETY SYSTEM IS ABSOLUTELY NECESSARY. NEVER PLACE YOUR FINGER ON THE TRIGGER UNLESS THE PISTOL IS POINTED IN A SAFE DIRECTION AND YOU ARE READY TO SHOOT IT.
TABLE OF CONTENTS DANGER NOTICE WARNINGS CAUTION NOTICE TABLE OF CONTENTS PISTOL DESCRIPTION MAGAZINE INTERLOCK SAFETY SYSTEM FIRING PIN BLOCK CHECKING THE CHAMBER LOADING & UNLOADING THE MAGAZINE UNLOADING THE PISTOL FIRING OPERATION ADJUSTING SIGHT DISASSEMBLY CLEANING ASSEM BL Y LOCKING STORAGE & TRANSPORT CASE BARREL & MAGAZINE COMPONENTS FRAME COMPONENTS SLIDE COMPONENTS ACCESSORIES/ORDERING INFORMATION LIFETIME WARRANTY 4 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15-16 17 18 19-20 21 22 23
PISTOL DESCRIPTION ( BARREL ADJUSTABLE REAR SIGHT HAMMER FIRING PIN BLOCK SLIDE SAFETY TAKE DOWN LEVER TRIGGER MAGAZINE RELEASE BUTTON MAGAZINE 5
MAGAZINE INTERLOCK SAFETY THIS SAFETY IS LOCATED AT THE TOP OF THE LEFT HAND GRIP AND CAN ONLY BE MOVED WHILE THE MAGAZINE IS FULLY INSERTED INTO THE PISTOL. BY MOVING THE SAFETY UP TO THE TOP OF THE GRIP. THE WORD "SAFE" WILL BE EXPOSED INDICATING THE PISTOL IS IN THE SAFE POSITION. WHILE IN THE "SAFE" POSITION. THE HAMMER ~)ff~II[ CANNOT BE COCKED OR UN-COCKED. ONLY WHEN THE SAFETY
FIRING PIN BLOCK THE FIRING PIN BLOCK LEVER IS LOCATED ABOVE THE SERRATED FINGER GRIP. ON THE LEFT SIDE OF THE SLIDE JUST BY ROTATING THE LEVER UP (COUNTERCLOCKWISE), A DOT WILL BE EXPOSED INDICATING THE FIRING PIN IS BLOCKED AND A PULL OF THE TRIGGER AND FORCE OF HAMMER STRIKING THE FIRING PIN WILL CAUSE ANY TRIDGE IN THE BARREL TO BE FIRED.
CHECKING THE CHAMBER WHENEVER PICKING UP ANY FIREARM. OR BEFORE STORING ANY FIREARM IT IS IMPORTANT TO CHECK THE CHAMBER FOR ANY LIVE ROUNDS. NEVER PLACE YOUR FINGER ON THE TRIGGER WHEN CHECKING THE CHAMBER. PLACE FIRING PIN BLOCK IN THE DOWNWARD POSITION COVERING THE RED DOT. PLACE THE MAGAZINE INTERLOCK SAFETY IN THE "SAFE" POSITION AND REMOVE MAGAZINE BY DEPRESSING MAGAZINE RELEASE BUTTON AND COMPLETELY REMOVE MAGAZINE. PULL SLIDE REWARD.
LOADING & UNLOADING THE MAGAZINE BEFORE ATTEMPTING TO LOAD MAGAZINE IT IS IMPORTANT THAT YOU READ AND FULLY UNDERSTAND ALL FUNCTIONS AND SAFE HANDLING OF THIS PISTOL. THE MAGAZINE. BARREL AND SLIDE ARE MARKED WITH PROPER CALIBER OF CARTRIDGE TO BE USED AND ALL MUST BE OF THE SAME CALIBER. PLACE ONE ROUND IN AT A TIME. WITH THE REAR OF THE ROUND AT MIDWAY IN THE TOP OF THE MAGAZINE PUSH DOWNWARD AGAINST THE MAGAZINE FOLLOWER AND THEN REARWARD.
UNLOADING PISTOL WHILE REMOVING CARTRIDGE FROM BARREL CHAMBER. KEEP THE PISTOL POINTED IN A SAFE DIRECTION. ROTATE FIRING PIN BLOCK LEVER DOWN (CLOCKWISE) COMPLETELY COVERING THE RED DOT. TAKE THE PISTOL IN YOUR RIGHT HAND WITH A FIRM GRIP. MAKING SURE YOUR FINGERS ARE NOT TOUCHING THE TRIGGER. WITH YOUR OTHER HAND FIRMLY GRASP THE SERRATED PORTION OF THE SLIDE AND PULL IT REARWARD AS FAR AS IT WILL GO. WITH THE SLIDE HELD AT ITS REARMOST POSITION. MOVE THE SAFETY UPWARD TO THE "SAFE" POSITION.
FIRING OPERATION PLACE FIRiNG PIN BLOCK LEVER IN THE DOWNWARD POSITION COVERiNG THE RED DOT, PLACE SAFE1Y IN THE "SAFE" POSITiON AND REMOVE MAGAZINE. LOAD MAGAZiNE FOLLOWING THE INSTRUCTIONS ON PAGE 9. REINSERT LOADED MAGAZiNE INTO PISTOl. TAKE THE PISTOL iN ONE HAND WITH A FiRM GRIP. WHiLE KEEPING YOUR FiNGERS OFF OF TRIGGER AND WITH PISTOL POINTED iN A SAFE DiRECTION, MOVE SAFE1Y INTO "FIRE" POSITION (KEEP FIRiNG PIN BLOCK LEVER IN THE DOWNWARD POSiTiON).
ADJUSTING SIGHT THIS PISTOL IS EQUIPPED WITH A FIXED FRONT BLADE SIGHT AND A WINDAGE ADJUSTABLE REAR SIGHT. THE REAR SIGHT IS ADJUSTED BY THE ADJUSTMENT SCREW LOCATED AT THE RIGHT REAR OF THE SLIDE. PISTOL SHOULD BE IN THE UNLOADED CONDITION BEFORE ANY ATTEMPT TO ADJUST SIGHT. 1 , t ,. . I jrr"'-,//\ IF BULLET IS HITTING TO THE RIGHT OF TARGET CENTER. SCREW TO THE RIGHT (CLOCKWISE). TURN IF BULLET IS HITTING TO THE LEFT OF TARGET SCREW TO THE LEFT (COUNTERCLOCKWISE). TURN CENTER. /..
DISASSEMBL THIS PISTOL PERFORMED ~ ~ Y MUST BE IN THE UNLOADED CONDITION (SEE UNLOADING PISTOL PAGE 10). BEFORE DISASSEMBLY IS PLACE FIRING PIN BLOCK LEVER IN THE DOWNWARD POSITION COVERING THE RED DOT. PLACE SAFETY IN THE "SAFE" POSITION. DEPRESS MAGAZINE RELEASE BUTTON AND REMOVE MAGAZINE. PUSH ON REAR OF TAKE DOWN LEVER FORWARD TOWARDS THE END OF THE BARREL AND LIFT BARREL END UP AND OUT OF SLIDE AND FRAME. TO REMOVE SLIDE.
CLEANING PISTOL SHOULD BE CLEANED AS SOON AS POSSIBLE AFTER FIRING. BEFORE ATTEMPTING TO CLEAN PISTOL, EMPTY CHAMBER AND MAGAZINE OF ANY AMMUNITION AND REMOVE ALL AMMUNITION FROM CLEANING AREA. COVER WORK AREA WITH OLD NEWSPAPER. IT IS BEST TO REMOVE BARREL FOR clEANING. ASSEMBLE KNOB ROD AND BRUSH. PLACE A FEW DROPS OF "BREAKFREE CLP" TO ROD AND BRUSH. INSTALL BRUSH INTO BORE FROM CHAMBER END AND WORK BACK AND FORTH 5 TIMES. ALLOW OIL TO PENETRATE FOR ABOUT FIVE MINUTES.
ASSEMBL Y REMOVE ALL AMMUNITION FROM WORK AREA. PLACE EMPTY MAGAZINE INTO FRAME. MOVE SAFETY TO "FIRE" POSITION. MOVE HAMMER TO COCKED POSITION. INSTALL TAKEDOWN FRAME UNDER CROSS LEVER BAR. Q~ INTO ~ PLACE SLIDE DOWN ON FRAME OVER EJECTOR AND MOVE IT TO ITS MOST FORWARD POSITION. ABOUT 1/4 INCH FARTHER FORWARD THAN THE FRAME. PLACE RECOIL SPRING OVER STOP POST AND DOWN INSIDE SLIDE. WHEN PLACING SPRING ROTATE SPRING OVER POST UNTIL SPRING WIRE END AT FRONT END OF SLIDE IS AT THE TOP. 15 ~.
IF YOUR PISTOL DID NOT COME WITH A THREE INCH BARREL USE YOUR OTHER EMPTY MAGAZINE AS SHOWN TO KEEP SPRING IN PLACE WHILE RECOILING SPRING. WHILE HOLDING THE SLIDE REARWARD ON THE FRAME. MOVE SAFETY TO "FIRE". ',\I ONLY ALLOW THE SLIDE TO MOVE FORWARD ABOUT 1/8 OF AN INCH. PLACE BARREL HOOK IN FRAME OVER PIN AND ROTATE DOWNWARD UNTIL IT LOCKS INTO PLACE. IF YOUR PISTOL CAME WITH A THREE INCH BARREL USE IT AS SHOWN WHILE RECOILING SPRING WHILE HOLDING FRAME AND COMPONENT USED TO RECOIL SPRING IN ONE GRIP.
LOCKING TRANSPORT CASE FOR TEMPORARY LIMITED ACCESS AND TRANSPORT ONLY. THIS IS NOT A SUBSTITUTE FOR A SAFE. ALL FIREARMS SHOULD BE KEPT IN A LOCKED SAFE WHEN NOT UNDER YOUR CONTROl. AMMUNITION SHOULD ALWAYS BE STORED SEPARATELY FROM PISTOl. ALWAYS CHECK FOR AN EMPTY CHAMBER BEFORE STORING OR TRANSPORTING.
BARRELS AND MAGAZINES # W236 NAME 205-.22 LR 3 INCH BARREL 230-.22 LR STD. MAGAZINE 236-.22 LR FOLLOWER 237-.22 LR MAG SPRING 238-.22 LR MAG BODY 239-.22 LR STD. MAG BASE 243- BASE LOCK 270-.22 LR 5 INCH BARREL 271 -.22 LR EXT. MAG BASE 260...22 LR EXT. MAGAZINE 305-.25 ACP 3 INCH BARREL 330...25 ACP STD. MAGAZINE 336-.25 ACP FOLLOWER 337 -.25 ACP MAG SPRING 338.25 ACP MAG BODY 339.25 ACP STD. MAG BASE 370.25 ACP 5 INCH BARREL 371 .25 ACP EXT. MAG BASE 360.25ACP EXT. MAGAZINE ~ym 18 PRICE 19.50 11.
FRAME C OMPONENTS 21 19
# NAME 201-FRAME NOT AVAILABLE 207-MAGAZINE BUTTON 208-SAFETY 209-LEFT GRIP (PLASTIC) 21 O-RIGHT GRIP (PLASTIC) 21 1-MAG CATCH 21 2-BARREL PIVOT PIN 21 3TRIGGER PIVOT PIN 21 4-DISCONNECTOR PIN 21 6-SEAR PIN 217 -TRIGGER 21 8-HAMMER PIN 219-DISCONNECTOR 220-RECOIL SPRING 222-SEAR SPRING 223-CATCH SPRING 224-TRIGGER SPRING 227-STRUT SPRING 228-GRIP SCREW (1) 240-TRIGGER BAR PIN 241-TRIGGER BAR 242-BLOCK SPRING 244-STOP POST 247-EJECTOR 248-STRUT 249-CROSS PIN 250-SAFETY BLOCK 251-TAKE DOWN LEVER 252-HAMMER P
SLIDE COMPONENTS 234 202 21 # NAME PRICE 202-SLIDE 203-EXTRACTOR 204-FIRING PIN 21 5-EXTRACTOR PIN 221 -FIRING PIN SPRING 226-EXTRACTOR SPRING 229-SIGHT SPRING 234-FRONTPLATE .22LR 242-BLOCK SPRING 245-SIGHT 246-REAR PLATE 253-FIRING PIN BLOCK 254-REAR PLATE SCREW 255-SIGHT SCREW 24.95 3.40 2.90 .75 .75 .75 .75 7.50 1.00 2.50 .40 .
NOTES
PHOEN TAKE YOUR AFFORDABLE, SUPERB PHOENIX HIGH HANDGUN IX ARMS@ MODEL H P ACCESSORI ARMS QUALITY AND ADD HP PISTOLS ACCESSORiES. TO YOUR TO THE EACH SHOOTING is NEXT LEVEL DESIGNED WITH TO ES OUR NEW IMPROVE AN LINE ENJOYMENT. HP LOCKING GUN TRANSPORT CASE $14.00 LOCKED GUN TRANSPORT CASE CAN BE KEYED THE SAME AS THE PISTOL MAGAZINE WELL LOCK. EXTENDED MAGAZINE $16.00 FOR LARGER HAND GRIP. lORD. CAPACITY. STANDARD MAGAZINE $11.50 10 RD. CAPACITY.
HP BELT NYLON HOLSTER $10.00 WITH ADJUSTABLE WEB STRAP. FITS EITHER LENGTH BARREL. H P PISTOL LOCK $12.00 INCLUDED WITH ALL PHOENIX ARMS MODELS. INSTALLS IN MAGAZINE WELL. CUSTOM HP HARDWOOD RESINATED GRIPS $18.00 DESIGNS, MATERIALS AND PRICES HP CLEANING KIT $8.00 COMES WITH ROD, BREAKFREE "CLP" GUN OIL, BRUSH, JAG END, SLOTTED END, PATCHES, SCREW AND KNOB. SUBJECT TO CHANGE WITHOUT NOTICE.
DETACH To ACTIVATE POSTAGE, THIS WITHIN & MAIL YOUR WARRANTY 30 MODEL DAYS SERIAL 1. WHERE DID YOU MUST COMPLETE IS THIS 3. DID YOU RECEIVE THIS OPERATING INSTRUCTIONS 4. DID 5.
ORDERING INFORMATION CALL WITH MASTERCARDNISA OR SEND CHECK/MONEY ORDER WITH $4.50 POSTAGE & HANDLING TO ADDRESS BELOW. BE SURE TO INCLUDE THE MODEL, FINISH, CALIBER AND SERIAL NUMBER WITH YOUR ORDER. DESIGNS AND PRICES SUBJECT TO CHANGE WITHOUT NOTICE. PHIEHIX 1420 SOUTH ARCHIBALD ONTARIO, CA 91761 909/937-6900 AVE.
PLACE POSTAGE HERE PHOEHIX WARRANTY DEPARTMENT 1420 SOUTH ARCHIBALD AVENUE ONTARIO, CA 91761
