manual

BLUETOOTH AT COMMAND LIST
7749_de_00 PHOENIX CONTACT 40
parameter integer This parameter has different meaning for different link policies.
Link policies with sniff (4-8):
Bit 0: Exit sniff on data activity. Only used when link policy supports sniff.
If set the SPA will try to temporarily exit sniff when receiving data on the serial
interface. When no data has been received on the serial interface for 1s, then
the link will be put back into sniff mode. If not set, then the link will always be in
sniff.
Using exit sniff on data activity may be useful when using longer sniff intervals
since these links have a low throughput.
Link policies with QoS (3,10,12):
If set to 0 then the shortest pollinterval possible is used. If different from 0 then
the value defines the pollinterval.
If multidrop is enabled, the pollinterval will not change until the max numbers of
clients are connected.
For the other link policies this parameter has no meaning and shall be set to 0.
Link policies with All packet sizes (0, 2, 3):
If set to 1, then the device is optimized for throughput.
Note, for link policy 3 a value of 1 will also set the shortest possible pollinterval.
parameter integer This parameter has different meaning for different link policies.
Link policies with sniff (4-8):
Bit 0: Exit sniff on data activity. Only used when link policy supports sniff.
If set the SPA will try to temporarily exit sniff when receiving data on the serial
interface. When no data has been received on the serial interface for 1s, then
the link will be put back into sniff mode. If not set, then the link will always be in
sniff.
Using exit sniff on data activity may be useful when using longer sniff intervals
since these links have a low throughput.
Link policies with QoS (3,10,12):
If set to 0 then the shortest pollinterval possible is used. If different from 0 then
the value defines the pollinterval.
If multidrop is enabled, the pollinterval will not change until the max numbers of
clients are connected.
For the other link policies this parameter has no meaning and shall be set to 0.
Link policies with All packet sizes (0, 2, 3):
If set to 1, then the device is optimized for throughput.
Note, for link policy 3 a value of 1 will also set the shortest possible pollinterval.
store_in_startup_database enumerator 0: The setting will only be valid for the current power cycle.
1: The Serial Port Adapter will remember the setting between power cycles. The
settings database in the Serial Port Adapter will be updated.