manual

BLUETOOTH AT COMMAND LIST
7749_de_00 PHOENIX CONTACT 23
Write_No_Of_Remote_Peers (AT*ADNRP=)
Read_Default_Remote_Peer (AT*ADRDRP=)
AT Command Description
AT*ADNRP=<no_of_remote_peers>,
<store_in_startup_database><CR>
This command writes the number of remote peers defined.
The number of remote peers may not be greater than the
number returned by the Read_Max_No_Of_Remote_Peers
command.
After writing the number of remote peers the host must use
the Write_Default_Remote_Peer command to write all the
remote peers to the Serial Port Adapter.
For more information see Read_No_Of_Remote_Peers.
Command Parameters Type Value
no_of_remote_peers integer The number of remote peers.
The default value is 0.
store_in_startup_database enumerator 0: The setting will only be valid for the current power cycle.
1: The Serial Port Adapter will remember the setting between power cycles. The
settings database in the Serial Port Adapter will be updated.
Responses Description
<CR><LF >OK<CR><LF> Successful response.
<CR><LF>ERROR<CR><LF> Error response.
AT Command Description
AT*ADRDRP=< peer_id ><CR> This command reads the Bluetooth device address and de-
vice name of the selected default remote peer (peer id).
Command Parameters Type Value
peer_id integer The peer ID can be between 0 and the value written by the Write_No_Of_Peers
command –1 or read by the Read_No_Of_Peers command –1.
Responses Description
<CR><LF>*ADRDRP:<bd_addr>,<connect_scheme>,
<update_remote_peer_on_incoming>,
<device_name><CR><LF>OK<CR><LF>
Successful response.
<CR><LF>ERROR<CR><LF> Error response.