User's Manual

3. Getting Start - Charging the battery
Before using BT Headset, you must charge the product for approximately 2 hours. When the
battery is fully charged, it provides up to 4 ~ 6 hours of talk time and up to 200 hours of standby
time.
1. Connect the charger cable to BT Headset
2. Plug the AC adapter into a wall outlet. When BT Headset is charging, red indicator light will
display.
3. When the battery is fully charged, the Red light is off.
4. Pairing the Bluetooth headset with Mobile phone (Pin Code : 0000)
Pairing is the process of linking the headset with your Bluetooth enabled mobile phone. After this
process is completed, you can use the BT Headset only with this paired mobile phone. If you want
to use it with another mobile phone, you must repeat the pairing process again. The BT Headset
can be paired with up to 8 compatible phones but connected to only one phone at a time.
1. Make sure that the Mobile phone is turned on and within 10 meters of the headset.
2. Turn on BT Headset and make sure the headset is charged. Press “Power on/off” button for 7
seconds. The blue and red LEDs will flash alternatively. Release both buttons and the headset
are now in pairing mode.
3. Activate the Bluetooth connection from the phone. You may need to consult with user guide of
your phone regarding how to do that.
4. Set the phone to start searching for Bluetooth devices as instructed in user guide of your phone.
5. Enter the pin code 0000 to connect (or “pair”) BT Headset to the phone. BT Headset beeps once
and an active Bluetooth connection is displayed by a blinking blue indicator light.
6. Start using the headset.
5. Disconnecting the Bluetooth headset from the phone
To disconnect BT Headset from the phone, do one of the following:
1 Turn off
2. Disconnect BT Headset in the phone menu.
3. Move the headset more than 10 meters away from the phone.
Note that you do not need to delete the pairing with the headset to disconnect it. When you
reconnect a paired headset, you will not be asked for its pin code again.
6. Reconnecting the paired Bluetooth headset to the compatible phone
To reconnect BT Headset to the last phone used, simply switch on the headset and it will
automatically connect to the phone. There are occasions when headset is temporarily out of
Bluetooth operating range (up to 10 meters, e.g. user wearing the headset walks away from the
phone), the headset will be disconnected from