User's Manual

ManualsBrandsPHOENIX Solutions ManualsAudio EquipmentBLUETOOTH MONO HEADSET

Table of Contents

1. Introduction........................................................ 2

2. The Packing Content..................................................................... 3

3. Getting Start - Charging the battery........................................................... 3

4. Pairing the Bluetooth headset with Mobile phone (Pin Code : 0000)...... 3

5. Disconnecting the Bluetooth headset from the phone.... 4

6. Reconnecting the paired Bluetooth headset to the compatible phone... 4

7. Powering Up........................................................................ 5

8. Making calls......................................................................... 5

9. Answering and ending a call.............................................. 5

10. Rejecting a call.................................................................... 5

11. Redialing the last dialed number....................................... 5

Summary of content (6 pages)

PAGE 1
Table of Contents 1. Introduction........................................................ 2 2 . T h e P a c k i n g C o n te n t . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 3. Getting Start - Charging the battery........................................................... 3 4. Pairing the Bluetooth headset with Mobile phone (Pin Code : 0000)...... 3 5. Disconnecting the Bluetooth headset from the phone.... 4 6.
PAGE 2
1. Introduction Thanks for purchasing BT Headset which is a stylish headset that enables comfortable handsfree communication with compatible phone that supports Bluetooth technology.
PAGE 3
n Incoming call –Blue light flashing 2 times every 3 second. n Active call –Blue light flashing once every 6 seconds.. n Power off –Red light constant on for 1 seconds and beep once. n Low battery – The Led frequency is ten times of the Led current status, and beep on every 20 seconds (3) Volume up: Increase the earpiece volume (4) Volume down: Decrease the earpiece volume (5) Charger connector: For headset battery charging (6) Earpiece: Relay the caller’s voice.
PAGE 4
3. Getting Start - Charging the battery Before using BT Headset, you must charge the product for approximately 2 hours. When the battery is fully charged, it provides up to 4 ~ 6 hours of talk time and up to 200 hours of standby time. 1. Connect the charger cable to BT Headset 2. Plug the AC adapter into a wall outlet. When BT Headset is charging, red indicator light will display. 3. When the battery is fully charged, the Red light is off. 4.
PAGE 5
the phone and user will hear a warning tone from the headset. Headset is now in powered on but no Bluetooth connection mode (blue light flashes once every 5 seconds). If the headset is back in range within 10 minutes, the BT Headset auto-reconnects with the last phone. If the headset is out of range for over 10 minutes, long press both Multifunction and Volume + buttons or both Multifunction and Volume - buttons to reactivate the connection. 7.
PAGE 6
FCC Information This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received; including interference that may cause undesired operation. Federal Communications Commission (FCC) Statement This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.