F4U Corsair Manual

F4U CORSAIR

Instruction Manual

Set all scerws securely. If they come

off during flight you will lose control

of your aircraft!

Warning!

Assemble left and right

sides the same way

Tie the string.

Pull out servo cord with string.

2. Attach the clevis to the outer hole in the control

horn. Install a silicone tube on the clevis.

3. Locate one nylon servo arm, and using wire

cutters, remove all but one of the arms. Using a

2mm drill bit, enlarge the third hole out from the

center of the arm to accommodate the aileron

pushrod wire.

4. Plug the aileron servo into the receiver and center

the servo. Install the servo arm onto the servo.

The servo arm should be perpendicular to the

servo and point toward the middle of the wing.

5. Center the aileron and hold it in place using a

couple of pieces of masking tape.

6. With the aileron and aileron servo centered,

carefully place a mark on the aileron pushrod wire

where it crosses the hole in the servo arm.

7. Using pliers, carefully make a 90 degree bend

down at the mark made. Cut off the excess wire,

leaving about 6mm beyond the bend.

1. Working with the aileron linkage for now, thread

one nylon clevis onto one of the threaded wires.

Aileron

Flap

2x10mm

INSTALLING THE AILERONs AND FLAPs

LINKAGES

< Left Wing >< Right Wing >

Flap Servo

Aileron Servo

Flap Servo

Aileron Servo

2 x 10mm TP Screw