F4U Corsair Manual

5. Place the aileron servo tray / hatch into the

servo box on the bottom of the wing and drill

pilot holes through the tray and the servo box

for each of the four mounting screws. Secure

the servo tray in place using the mounting

screws provided .

6. Repeat step # 2 - # 5 to install the second

aileron servo in the opposite wing half.

approx. 13mm

2mm

< Bottom view >

F4U CORSAIR

Instruction Manual

3. Place the servo into the servo tray. Center the servo

within the tray and drill pilot holes through the block

of wood for each of the four mounting screws

provided with the servo.

4. Using the thread as a guide and using masking

tape, tape the servo lead to the end of the

thread: carefully pull the thread out. When you

have pulled the servo lead out, remove the

masking tape and the servo lead from the

thread.

INSTALLING THE AILERONs AND FLAPs

SERVOS

1. Install the rubber grommets and brass eyelets onto

the aileron servo.

2. Using a modeling knife, remove the covering from over

the pre-cut servo arm exit hole on the aileron servo

tray / hatch. This hole will allow the servo arm to pass

through when installing the aileron pushrods.

Cut away film only. here

Supplied with the servo

1.5mm

Aileron and Flap Servo

Must be purchased

separately!

Assemble left and right

sides the same way

Cut off shaded portion

2x10mm

Aileron

For Aileron servo

For Flap servo

Flap