PC-21 Pilatus Mk2 GP EP Gas ARF Manual

PC21 PILATUS MK2
Instruction Manual
5
PREPARATIONS
Use a covering iron with a covering sock on
high heat to tighten the covering if necessary.
Apply pressure over sheeted areas to
thoroughly bond the covering to the wood.
TEMPORARY PIN
TO KEEP HINGE
CENTERED
INSTALLING THE AILERONS AND FLAPS
1. Test fit the ailerons to the wing with the hinges.
If the hinges don’t remain centered, stick a pin
through the middle of the hinge to hold it in
position.
2. Apply six drops of thin CA to the top and bottom
of each hinge. Do not use CA accelerator. After
the CA has fully hardened, test the hinges by
pulling on the aileron.
Aileron
Flap
< Bottom view >
Main Wing