EP Gas ARF Manual

PIPER J3 CUB

Instruction Manual

INSTALLING THE AILERONs AND FLAPs

LINKAGES

1. Working with the aileron linkage for now, thread one

nylon clevis at least 14 turns onto one of the

threaded wires.

2. Attach the clevis to the outer hole in the control horn.

3. Locate one nylon servo arm, and using wire cutters,

remove all but one of the arms. Using a 2mm drill

bit, enlarge the third hole out from the center of the

arm to accommodate the aileron pushrod wire.

4. Plug the aileron servo into the receiver and center

the servo. Install the servo arm onto the servo. The

servo arm should be perpendicular to the servo and

point toward the middle of the wing.

5. Center the aileron and hold it in place using a couple

of pieces of masking tape.

6. With the aileron and aileron servo centered,

carefully place a mark on the aileron pushrod wire

where it crosses the hole in the servo arm.

7. Using pliers, carefully make a 90 degree bend

down at the mark made. Cut off the excess wire,

leaving about 6mm beyond the bend.

8. Insert the 90 degree bend down through the hole in

the servo arm. Install one nylon snap keeper over

the wire to secure it to the arm. Install the servo

arm retaining screw and remove the masking tape

from the aileron.

9. Repeat step # 4 - # 8 to install the second aileron

linkage. After both linkages are completed,

connect both of the aileron servo leads using a

Y-harness you have purchased separately.

Must be purchased separately!

Set all scerws securely. If they come

off during flight you will lose control

of your aircraft!

Tie the string.

Pull out servo cord with string.

2 x 10mm TP Screw

Warning!

2x10mm

Aileron ServoAileron Servo

< Left Wing >< Right Wing >

Flap ServoFlap Servo

Assemble left and right

sides the same way