EP Gas ARF Manual

Apply instant glue

(CA glue, super glue).

INSTALLING THE pilot

PIPER J3 CUB

Instruction Manual

INSTALLING THE SWITCH

1. The switch should be mounted on the fuselage

side, opposite the muffler, close enough to the

receiver so the lead will reach. Use the face plate

of the switch cut out and locate the mounting

holes.

2. Cut out the switch hole using a modeling knife.

Use a 2mm drill bit and drill out the two mounting

holes through the fuselage side.

3. Secure the switch in place using the two machine

screws provided with the radio system.

INSTALLING THE RECEIVER AND BATTERY

1. Plug the servo leads and the switch lead into the

receiver. You may want to plug an aileron

extension into the receiver to make plugging in the

aileron servo lead easier when you are installing

the wing. Plug the battery pack lead into the

switch.

2. Wrap the receiver and battery pack in the protective

foam to protect them from vibration. Use a rubber

band or masking tape to hold the foam in place.

Do not permanently secure the receiver and battery

until after balancing the model.

Must be purchased

separately!

Foam Pad

Tape

Battery

Foam Pad

Receiver

Tape

Switch

Off

Velcro

Open and close

Door

# 26 - Pilot

Chair

200mm Velcro