EP Gas ARF Manual

INSTALLING THE THROTTLE PUSHROD SERVO

1. Place the engine into the engine mount and align it

properly with the front of the cowling.

If your engine is equipped with a remote needle

valve, we suggest installing it into the engine at

this time.

2. Slide the pushrod housing through the hole in the

firewall, through the hole in the forward bulkhead,

and into the servo compartment.

3. Apply epoxy glue to the pushrod housing where it

exits the firewall and where it passes through the

forward bulkhead. This will secure the housing in

place.

4. Using a modeling knife, cut off the nylon pushrod

housing 26mm in front of the servo tray.

Temporarily install the engine and

make a hole for the throttle rod by

aligning with the position of the

throttle lever.

Throttle rod

PP Pipe

Apply instant glue

(CA glue, super glue).

PIPER J3 CUB

Instruction Manual

Plate of

Wood