User Manual

30
Control horn
Screw
Remove the covering from the hole as shown.
The elevator control horn should be mounted on
the bottom of the elevator at the leading edge, IN
LINE WITH THE ELEVATOR PUSHROD
Cut the covering from the exit slot for the rudder
pushrod on the top of the fuselage, on the left side
of the vertical fin.
The rudder control horn should be mounted on the
left of the rudder at the leading edge, IN LINE
WITH THE RUDDER PUSHROD.
ELEVATOR - RUDDER LINKAGE
7
29
Elevator pushrod exit
27
To Carburator
To muffler
Insert the Z-bend of the throttle pushrod into the
throttle arm of the engine. See the "high throttle"
photo on page 9
Install the engine of your choice using the Philip
head screws. Make sure the engine is pointing
straight ahead or pointing a little to the right, i. e.
with right thrust. Mark the locations of the screws
and drill mounting holes with a drill bit that is
slightly smaller than the screw threads. Test to get
the right size drill bit before drilling holes in the
engine mount.
Install the rubber grommets and brass eyelets into
the elevator, rudder and throttle servos. Test fit the
servos into the servo tray.
Mount the servos to the tray using the mounting
screws provided with your radio system.
ENGINE INSTALLATION
SERVO INSTALLATION
Down thrust 2
0
Right thrust 2
0
28
Rudder servo
Throttle servo
Elevator servo
Instruction Manual
Trainer 60
Downloaded from www.Manualslib.com manuals search engine