User Manual

6
24
Nose gear
Wire
pushrod
Steering arm
22
Screw
Landing gear
Nylon step
Fit the nose leg steering arm onto the "Z" bend on
the steering pushrod. Now slide the steering arm
into the middle of the pre-fitted nylon nose gear
bearing. Hold the nose gear steering arm in place
then slide the nose wire into the nylon mount,
passing through the steering arm.
Note that the ground flat section of the leg should
face forward. Now tighten the nose gear steering
arm retaining screw onto the nose leg. This will
ensure that the nose leg cannot turn in the
steering arm.
Install nose wheel using supplied wheel collars.
Put wheels on the gear and secure using the
wheel collars.
Collar
23
MAIN GEAR INSTALLATION
Cut the covering from the slot in the landing gear
mount.
Put landing gear wires in fuselage bottom and
secure using screws and nylon straps.
FUEL TANK INSTALLATION
Assemble the fuel tank.
25
Collar
Instruction Manual
Trainer 60
Put the fuel tank in the fuselage using foam rubber
to cushion the tank, and route the fuel lines out
the hole in the firewall.
26
To Carburator
To muffler
21
Glue epoxy
Downloaded from www.Manualslib.com manuals search engine