Datasheet

https://www.phoenixcontact.com/us/products/2905249
04/10/2017Page3/12
Thermocouple measuring transducer-MINI MCR-2-TC-UI-PT-2905249
Technical data
Connection data
Connection method Push-in connection
Single conductor/terminal point, solid, with ferrule, min. 0.14 mm²
Single conductor/terminal point, solid, with ferrule, max. 2.5 mm²
Single conductor/terminal point, solid, without ferrule, min. 0.14 mm²
Single conductor/terminal point, solid, without ferrule, max. 2.5 mm²
Conductor cross section flexible min. 0.14 mm²
Conductor cross section flexible max. 2.5 mm²
Min. AWG conductor cross section, flexible 24
Max. AWG conductor cross section, flexible 12
Stripping length 10 mm
General
Transmission error thermocouples
0.1%*600K / setmeasuring range; 0.1%>600K(C, E, J, K, N, T, L, U,
M Gost, L Gost)
0.2 % * 600 K / set measuring range; 0.2 % > 600 K (B, R, S, A1, A2, A3)
0.2%* 600K / set measuring range; 0.2%> 600K (E, J, K, N, T, L, U, M
Gost, L Gost); Highspeed Mode
0.4%* 600K / set measuring range; 0.4%> 600K (B, R, S, A1, A2, A3);
Highspeed Mode
Maximum temperature coefficient ≤ 0.01 %/K
Typical cold point errors 2 K (2 K + (0,2 K * ΔT))
Protective circuit Transient protection
Electrical isolation Reinforced insulation in accordance with IEC 61010-1
Overvoltage category II
Degree of pollution 2
Rated insulation voltage 300 V (effective)
Test voltage, input/output/supply 3 kV (50 Hz, 1 min.)
Electromagnetic compatibility Conformance with EMC directive
Noise emission EN 61000-6-4
Noise immunity
EN 61000-6-2 When being exposed to interference, there may be minimal
deviations.
Housing material PBT
Mounting position any
Assembly instructions
The T connector can be used to bridge the supply voltage. It can be
snapped onto a 35 mm DIN rail according to EN 60715.
Conformance CE-compliant
ATEX  II 3 G Ex nA IIC T4 Gc X
UL, USA/Canada UL 508 Listed
Class I, Div. 2, Groups A, B, C, D T6