Datasheet

https://www.phoenixcontact.com/us/produkte/1987724
Nov 13, 20132/6
PCB terminal block-PT 2,5/ 2-5,0-V-1987724
Technical data
General
Nominal current I
N
32 A
Nominal cross section
2.5 mm²
Maximum load current
32 A (current values dependent on no. of pos., dimensioning of
printed circuits, and ambient temperature)
Insulating material
PA
Solder pin surface
Sn
Inflammability class according to UL 94
V0
Internal cylindrical gage
A3 / B3
Stripping length
6.5 mm
Number of positions
2
Screw thread
M3
Tightening torque, min
0.45 Nm
Tightening torque max
0.5 Nm
Connection data
Conductor cross section solid min.
0.5 mm²
Conductor cross section solid max.
4 mm²
Conductor cross section stranded min.
0.5 mm²
Conductor cross section stranded max.
4 mm²
Conductor cross section stranded, with ferrule without plastic
sleeve min.
0.5 mm²
Conductor cross section stranded, with ferrule without plastic
sleeve max.
2.5 mm²
Conductor cross section stranded, with ferrule with plastic
sleeve min.
0.5 mm²
Conductor cross section stranded, with ferrule with plastic
sleeve max.
2.5 mm²
Conductor cross section AWG/kcmil min.
20
Conductor cross section AWG/kcmil max
10
2 conductors with same cross section, solid min.
0.5 mm²
2 conductors with same cross section, solid max.
1.5 mm²
2 conductors with same cross section, stranded min.
0.5 mm²
2 conductors with same cross section, stranded max.
1.5 mm²
2 conductors with same cross section, stranded, ferrules
without plastic sleeve, min.
0.5 mm²
2 conductors with same cross section, stranded, ferrules
without plastic sleeve, max.
0.75 mm² The technical data regarding clamping with ferrules
applies only when using crimping pliers ZA 3. When using ferrules,
it is necessary to take into account possible restrictions regarding
nominal voltage.
2 conductors with same cross section, stranded, TWIN
ferrules with plastic sleeve, min.
0.5 mm²
2 conductors with same cross section, stranded, TWIN
ferrules with plastic sleeve, max.
1.5 mm² The technical data regarding clamping with ferrules
applies only when using crimping pliers ZA 3. When using ferrules,
it is necessary to take into account possible restrictions regarding
nominal voltage.
Minimum AWG according to UL/CUL
20