Daim Ntawv Qhia Tus Neeg Siv

www.phocos.com 1 | P a g e
1.0 Introduction
This guide outlines the recommended settings and establishing communication for operation of one or more Any-
Grid™ PSW-H-5KW-230/48V, PSW-H-5KW-120/48V, PSW-H-6.5KW-120/48V or PSW-H-8KW-230/48V hybrid inverter
chargers with the following ZRGP battery modules, referred to in this guide as “battery modules”:
Battery module series
Battery model name
ZR-FC series
ZR-FC24200
ZR-FC4850
ZR-FC48100
Power Base X1
X1-48100
Power Base Mate LV series
Mate LV_50 Series
Mate LV_100 Series
Note that the charge/discharge settings are automatically negotiated with the battery if this guide is used and
cannot be changed.
The Any-Grid must be installed according to the Any-Grid “User and Installation Manual” included with every Any-
Grid unit and available online at www.phocos.com. The battery terminals of the Any-Grid must be connected to the
batteries according to the ZRGP battery installation manual at the appropriate step mentioned in the chapter “5.0
Battery Settings and Communication Cable Installation” of this manual.
WARNING: Be sure to read and respect the warnings in the installation manuals of the Any -Grid, the battery
modules and any other connected equipment. The installation must be conducted by a trained professional.
2.0 Requirements
The following is required to proceed with this guide:
• Any-Grid PSW-H-5KW-230/48V, PSW-H-5KW-120/48V, PSW-H-6.5KW-120/48V or PSW-H-8KW-230/48V
Note: the minimum display unit firmware version U2 must be 06.18 or later, with the corresponding
U1 firmware for your Any-Grid PSW-H.
• Battery communication cable with only the following pins connected:
Any-Grid PSW-H side ZRGP battery side
Make sure the cable is correctly oriented between the battery and PSW-H unit when installing below.
WARNING: Do not use the inverter cable included with your ZRGP batteries. Wiring your own cable
according to the pinout above must be done at your own risk. Any damage to the PSW-H or battery
due to incorrect wiring, cable orientation or use of an incorrect cable is not covered by any warranty.
• One of the battery module(s) defined in “1.0 Introduction” of this manual
Pin 8 1
Pin 7 2
Pin 6 3
Pin 5 4
Pin 4 5
Pin 3 6
Pin 2 7
Pin 1 8