Datasheet

• Electronicallyregulatedchargingmode:boost,main
andfloatcharge
• Deepdischargeprotection
• PWMseriesregulation(PVpanelisnotshort-circuited)
• Integratedtemperaturecompensation
• Fullyelectronicallyprotectedagainst:panelsurge
voltage,wrongpolarity(panelorbattery),overloadand
shortcircuitatload
• ThreeLEDindications:ChargeStatus,SOC,LVD,Over-
load/ShortCircuit
• IP68protection
ECO (10 A)
Solar Charge Controller
Type ECO 10
System voltage 12 V
Max. charge/load current 10 A
Float charge 13.8 V(25 °C)
Main charge 14.4 V (25 °C), 0.5 h (daily)
Boost charge 14.4 V (25 °C), 2 h
Activation: battery voltage < 12.3 V
Deep discharge protection, 11.0 V
Cut-off voltage
Overvoltage protection 15.5 V
Undervoltage protection 10.5 V
Max. PV panel voltage 30 V
Temperature compensation –4 mV/K
Idle self-consumption 4 mA
Grounding Positive grounding
Ambient operating temperature –40 to +60 °C
Max. altitude 4,000 m above sea level
Battery type Lead acid (GEL, AGM, flooded)
Wire cross section 2.5 mm
2
Weight 110 g
Dimensions (W x H x D) 87 x 51 x 16 mm
Type of protection IP68
battery SOC and load status (load disconnect).
Rural electrification systems are the typical applications for
this product. It is a perfect solution for cost-sensitive
systems.
The new version of the ECO solar charge controller series is
especially designed for small solar systems requiring
low-battery disconnect. The ECO series is fully electronically
protected. Three LEDs display charging progress,
Datasheet_ECO_1/1_e_2013-11-06_Subject to change without notice
www.phocos.com
Phocos AG
Magirus-Deutz-Str. 12
89077 Ulm, Germany
Tel. [phone]
Fax [phone]