User Guide

2 Take out the original adapter and screw the D-type adapter onto
the water purier housing. (Fig. 19)
3 Push the water purier housing onto the tap from below and
tighten the 4 screws evenly (Fig. 20).
4 Screw the attachment nut rmly onto the water purier
housing (Fig. 21).
Makesuretherubberwasherisrmlypushedagainstthetaptoprevent
waterleakage.

1 Make sure the tap is closed.
2 Set the water selection lever to the unltered stream
position (Fig. 22).
3 Tilt the lter cartridge 90° backwards and insert it into the water
purier housing. (Fig. 23)
4 Pull the cartridge upwards until it is in upright position. (Fig. 24)

1
Make sure that the water purier housing and the lter cartridge
are properly installed.
2 Turn the water selection lever to the desired setting (‘click’).
Filtered spray
Selectthissettingfordrinking,washingvegetablesorfruitsand
forcooking.
1 Turn the water selection lever until the ltered spray symbol is
aligned with the indicator (Fig. 25).
Do not let water hotter than 50°C run through the water purier at
this setting, as this may damage the water purier.
ENGLISH10