User manual

automatically. Remove the cause of overheating, unplug the appliance and let it cool down for

approx. 20 minutes. Then switch the appliance back on by plugging it in again.

This appliance allows you to choose the light intensity level you want to wake up to (see section

‘Setting the light intensity level’ in chapter ‘Using the appliance’).

If you often wake up too early or with a headache, reduce the light level.

If you share a bedroom with someone else, this person may unintentionally wake up from the

light of the appliance, even though this person is further removed from the appliance. This

phenomenon is the result of differences in light sensitivity between people.

If you start having trouble waking up again, this is possibly due to a decrease in the lamp’s light

output that occurs after some time. In that case, you can increase the light level or replace the

lamp.

If the appliance is used in an industrial area and/or near a power station, it may occur that, under

certain circumstances, the lamp goes off after it has come on. This does not have an adverse or

harmful effect on the safe functioning of the appliance the next time it is used.



This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this user manual, the appliance is safe to use based on

scientic evidence available today.

Preparing for use

Screwthelampintotheappliancebeforeyouusetheapplianceforthersttime.

Installation

1 Beforerstuse,openthehatchinthebackoftheappliance(seechapter‘Replacement’)and

screwthelampintothelampholder.

Note: You nd the lamp in a cardboard box inside the appliance.

2 Placetheapplianceat40-50cmfromyourhead,forexampleonabedsidetable(Fig.6).

3 Putthepluginthewallsocket.

Thetimeonthedisplaystartsashingandarrowsappearaboveandbelowthetimeto

indicatethattheclocktimehastobeset(Fig.7).

Note: If the display does not light up after you have plugged in the appliance, press the reset button on

the bottom of the appliance.

Setting the clock time

1 Use the ^andthe%buttonstosetthetime.

2 Holdthebuttondownlongertoputthetimeforwardorbackwardmorequickly.

Note: After you have set the time for the rst time, you have to press the ‘set time’ button before you can

adjust the time again. The time on the display starts ashing and arrows appear above and below the

time to indicate that the clock time can be set.

3 Whenyouhavesetthecorrecttime,pressthe‘settime’buttontoconrmthetime(Fig.8).

Thetimeonthedisplaystopsashingandthearrowsdisappear.

Note: If you do not conrm the time, the ashing stops and the arrows disappear after 10 seconds. This

indicates that the time has been set.

The appliance is now ready for use.

ENGLISH8