User manual

Note: The alarm function remains active and the light ring round the alarm button continues to burn.
2 Whenyouhaveswitchedonthereadinglampand/ortheradio,pressthe3 button to switch
offthereadinglampand/ortheradio.
When you press the
3 button again, only the light goes on.
Note: When the alarm function is active, pressing the 3 button does not affect the alarm settings.
Reading lamp
1 Press the @&buttontoswitchthelamponoroff.(Fig.21)
2 Turnthelightadjustmentwheel@upwardsordownwardstoincreaseordecreasethelight
intensitylevel.(Fig.16)
Thelightlevelindicationonthedisplay
@showsthelightintensitylevel(00to20).(Fig.23)
Tip: We advise you to set the light intensity to 20 (maximum level) for reading. If this light level is not
strong enough, switch on an extra lamp.
Note: The light intensity level you select is automatically set as the light intensity level for the alarm as
well.
Ifnecessary,donotforgettosetthelightintensitylevelbacktothewake-uplevel!
Radio
1 PresstheRADIObuttontoswitchontheradio(Fig.24).
Thelightringroundthebuttongoeson(Fig.25).
2 Use the %andthe^buttonstoselectthefrequencyofyourfavoritestation.(Fig.26)
You can choose FM stations.
Note: To scan radio frequencies automatically, press and hold the the % or the ^button for approx. 2
seconds.
3 PresstheRADIObuttontoswitchofftheradio(Fig.24).
Power failure
To make sure the alarm goes off at the set time after a short power failure, the appliance has been
provided with a backup system. This system has a self-charging battery that does not have to be
replaced. The system remembers the time for a few minutes.
Afteralongpowerfailure,thedisplayshowsanincorrectclocktimeandthealarmtimeis
00.00.Setthecorrectclocktime(seechapter‘Preparingforuse’)andthecorrectalarmtime
(seechapter‘Usingtheappliance’)(Fig.7).
Reset
1 Iftheappliancedoesnotrespondwell,removetheplugfromthewallsocketandthen
reinsertit.Ifthisdoesnothelp,presstheresetbuttononthebottomoftheapplianceto
resetthedisplaytothefactorydefaultsettings(Fig.27).
Cleaning and maintenance
Alwaysunplugtheapplianceandletitcooldownforapprox.15minutesbeforeyoustart
cleaningit.
Neverusescouringpads,abrasivecleaningagentsoraggressiveliquidssuchaspetroloracetone
tocleantheappliance.
Regularlyremovedustfromtheinsideoftheappliancewithadrycloth,asaccumulateddust
closetoapowerfullamppresentsapotentialrehazard.
,
,
,
ENGLISH 11