User Guide

f Confirm with the OK button. Your programming details
will then appear on the TV screen.
TIMER
VIDEOPLUS PROGRAMMING
VPS
DATE PROG. START PDC END LP
01 BBC1 20:00 21:30
________________________________
TO STORELP/SP
PRESS SELECT PRESS OK
DYou need to confirm the programme number the first
time you programme the video recorder with VIDEO
Plus+.
DIf VIDEO Plus+ does not recognise the TV channel,
’PLEASE ENTER PROGRAMME NUMBER’ will
appear on the TV screen. Instead of ’PLEASE
ENTER PROGRAMME NUMBER’, you can select
the programme number you want with the number
buttons 0-9 and confirm with the OK button.
DIf ’VIDEO PLUS CODE WRONG’ appears on the
TV screen, this means you entered an incorrect
PlusCode number or the incorrect date. Correct your
instructions or end with the TIMER k button.
DIf ’WEEKEND PROGRAMMING - NOT
POSSIBLE’ appears on the TV screen, the date
was incorrectly entered. ’Daily’ programming can
only be used for recordings to be made from
Mondays to Fridays.
DUse the SELECT button to switch ’VPS/PDC’ on or off
in ’START’.
DUse the SELECT button to select the recording
speed ’SP’ or ’LP’ in ’END’.
g Confirm with the OK button when the information is
correct.
DThe programming information has been stored in a
TIMER block.
h To end, press the TIMER k button.
i Make sure that the cassette you have put in can be
recorded on.
j Switch off with the STANDBY m button.
The programmed recording will only function when the
video recorder is switched off with the STANDBY m
button.
DIf any of the TIMER blocks are in use, ’k’ will light up
on the video recorder display.
DWhile a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press the
STANDBY m button.
DIf the video recorder is switched on a few minutes
before a programmed recording is supposed to
begin, ’SWITCH TO STANDBY - TIMER
RECORDING’ will flash on the TV screen.
DIf you reach the end of the cassette during a
recording, the video recorder will automatically
eject the cassette.
DIf you forget to load a cassette, ’NO CASSETTE’
will appear on the TV screen and ’k’ will flash on the
video recorder display.
DIf you have put in a cassette which cannot be used
for recording, the video recorder will automatically
eject it.
DIf ’TIMER FULL’ appears on the TV screen when
you press the TIMER k button, you have used up all
the available TIMER blocks. If you want to clear or
check a TIMER block, select it with the ;P or
P = button.
DProgramme number ’AUX’ is provided for audio
recordings via sockets AUX IN L R .
21